PUMP GP-WATER 2169735 - Caterpillar

TYPE="TABLE" @@@-->
Illustration 1 g03412485
Table 1
Specification for 381-0522 Engine Oil Lines Gp
Item Qty Part Specification Description
1 2 6B-9202 Spring Length under test force is 68.3 mm (2.69 inch).
Test force is 84.5 to 99.6 N (19.0 to 22.4 lb).
Free length after test is 112.7 mm (4.44 inch).
Cooling jet sequence valves must start to open at a pressure difference of 130 30 kPa (19 4 psi)
Cooling jet sequence valves must be fully open at 200 30 kPa (29 4 psi)
2 1 2W-1053 Plug Torque to 100 15 N m (74 11 lb ft).
3 4 4F-8965 Bolt Use the following procedure in order to tighten the bolts of the clamp assembly:
1. Tighten the clamp assembly until the clamp assembly snug to tube.
2. Tighten the clamp assembly to the elbow.
3. Tighten the clamp assembly to the tube.
4 4 0S-1571 Bolt
5 2 237-7623 O-Ring Seal Lubricate the bore lightly with the lubricant that is being sealed.
6 1 124-4273 Bypass Valve The oil cooler bypass valve to open with a pressure difference of 180 20 kPa (26 3 psi) .
7 1 2W-1635 Spring Length under test force is 102.0 mm (4.02 inch).
Test force is 518 26 N (116 6 lb).
Free length after test is 143.4 mm (5.65 inch).