PUMP & MTG GP-UNIT INJ HYD 2213462 - Caterpillar

Table 2
C32 Default Settings    
Parameter    Setting    
Engine Acceleration Rate     500    
Low Idle Speed     900    
Engine Speed Droop     3.0    
Engine State Control Input Configuration     Can Input    
Remote Throttle Control Min Speed     125    
Remote Throttle Control Max Speed     125    
Crank Terminate RPM     400    
Droop Mode Selection     Isochronous    
Ether Control     Disabled    
Desired Speed Input Configuration     PWM    
Secondary Desired Speed Input Configuration     Can Input    
Coolant Level Sensor     Installed    
Droop/Isochronous Switch Enable     Disabled    
Emergency Shutdown Override Switch Installation Status     Not Installed    
Emergency Shutdown Override Input Configuration     Switch to Ground    
Remote Emergency Stop (E-Stop) Switch Input Type Configuration     Normally Closed (to Ground)    
Air Intake Shutoff Detection Installation Status     Not Installed    
Engine Oil Temperature Sensor Installation Status     Installed    
Governor Gain Factor 1     Do Not Adjust    
Governor Minimum Stability Factor 1     Do Not AdjustGovernor Maximum Stability Factor 1Do Not Adjust    
Table 3
G3516B Default Settings    
Parameter    Setting    
First Desired Timing     22    
Fuel Quality Input Type Configuration     Configured Value    
Fuel Quality     905    
Fuel Quality Sensor LHV Lower Setpoint     300    
Fuel Quality Sensor LHV Upper Setpoint     850    
Gas Specific Gravity     0.598    
Fuel Specific Heat Ratio     1.300    
Desired Emissions Gain Adjustment Percentage     98    
Air/Fuel Proportional Gain     0    
Air/Fuel Integral Gain     0    
Low Idle Speed     1200    
Minimum Engine High Idle Speed     1700    
Maximum Engine High Idle Speed     1900    
Engine Acceleration Rate     50    
Desired Speed Input Configuration     0-5 VDC Input    
Governor Type Setting     Isochronous    
Engine Speed Droop     0.0    
Governor Gain Factor     0    
Governor Stability Factor     0    
Governor Compensation Factor     0    
Auxiliary Proportional Governor Gain 1     0    
Auxiliary Integral Governor Gain 1     0    
Auxiliary Derivative Governor Gain 1     0    
Driven Equipment Delay Time     0    
Crank Terminate RPM     400    
Engine Purge Cycle Time     0    
Cooldown Duration     0    
Cycle Crank Time     30    
Engine Overcrank Time     120    
Engine Speed Drop Time     15    
Engine Pre-Lube Time Out Period     120    
High Inlet Air Temperature Engine Load Set Point     50    
Impending Shutdown Delay Enable Status     0    
Impending Shutdown Delay Time     0    
Generator Output Power Sensor Scale Factor     310.17    
Generator Output Power Sensor Offset     0    
Engine Driven Accessory Load Configuration     23