PUMP GP-FUEL INJECTION 2217146 - Caterpillar

Illustration 1 g03402105
Right Console (1) Display unit (2) Propel lever (3) Vibratory control switchDisplay unit (1) is located on the right console. The display unit provides vibratory information to the operator. The display unit communicates with the machine ECM through the CAN lines.Note: Display unit (1) is installed only on machines with the variable frequency vibratory system. Vibratory control switch (3) is located on top of propel lever (2). The vibratory control switch is a latching, push-button switch. The switch has an ON position and an OFF position.Vibratory control switch (3) serves as the master switch for the vibratory system. On standard machines, the vibratory control switch transfers supply power to the vibratory system. On display option machines, the vibratory control switch sends an input signal to the machine ECM. The machine ECM controls the status of the vibratory system.
Illustration 2 g03402106
Right Console (4) Throttle control switch (5) Frequency adjust switch (optional) (6) Amplitude select switch (7) Vibratory mode switchThe vibratory system switches are located on the right console. The console contains the following vibratory switches:
Throttle control switch (4)
Frequency adjust switch (5) (variable frequency option)
Amplitude select switch (6)
Vibratory mode switch (7) On standard machines, each of the above switches provides a given vibratory control function. On machines with the display option, the machine ECM uses the input from these switches to determine the desired operating conditions for the vibratory system.Throttle control switch (4) is a rocker switch with two positions. This switch allows the operator to select either low idle engine operation or high idle engine operation. The throttle control switch must be in the HIGH IDLE position for the vibratory system to operate.Frequency adjust switch (5) is a rocker switch with three positions. This switch is used to increase or decrease the vibratory frequency. The center position of this switch is the HOLD position. The right position of this switch is the INCREASE position. The left position of this switch is the DECREASE position. The frequency adjust switch is spring returned to the HOLD position.Note: Frequency adjust switch (5) is installed only on machines with the variable frequency vibratory system. On variable frequency systems, vibratory frequency can range from 1400 50 vpm to 1830 50 vpm. Each time the frequency is changed, a pop-up window appears on the display unit. The pop-up window shows the currently chosen vibratory frequency. The machine ECM stores the last active frequency value in memory. This action allows the system to start up at the last chosen frequency after the engine start switch has been cycled through the OFF position. Amplitude select switch (6) is a rocker switch with three positions. This switch allows the operator to select the vibratory amplitude. The right position of this switch is the HIGH AMPLITUDE position. The left position of this switch is the LOW AMPLITUDE position. The center position of this switch is the OFF position. When the amplitude select switch is in the OFF position, the vibratory system does not operate.Indicator lights are located