PUMP GP-PISTON 2259236 - Caterpillar

Illustration 1 g02928076
(14) Implement select switch (15) Blade float indicator (16) Operator console power switch (17) Horn button (18) Implement lockout switch (19) Auto blade assist/autocarry or autorip enable switch (20) Single/dual blade tilt switch (21) High-idle engine speed select dial (22) Machine light switch (23) Bidirectional/enhanced auto shift switch (24) Auto kickdown switch (25) Machine power/engine crank switch (26) Operator console commanded stop switch (27) Parking brake switch
Confirm that the Commanded Stop switch (26) on the remote console is turned off, turn the switch in the clockwise direction in order to disengage.
Turn the following switches to the default position.
"IMPLEMENT LOCKOUT" (18) ON
"PARKING BRAKE" (27) ON
"MACHINE POWER/ENGINE CRANK" (25) OFF
"IMPLEMENTS CONTROL" (13) CENTER
"STEERING / DIRECTION CONTROL" (4) CENTERNote: The default positions of these switches are noted by yellow icons.
Make sure that the operator console is upright.Note: The operator console has a built-in inclinometer which prevents operation when the console is tilted past 60 degrees in any direction.
Turn the operator console power switch (16) to the "ON" position in order to power on the operator console.
Quickly cycle the Commanded Stop switch (26) from on (pushed in) to off (twist out).Note: Step 4 and Step 5 must be completed within 10 seconds.
Illustration 2 g03475457
(37) Remote active LED (42) Software stop LED (43) Active Fault LEDNote: The 3 dashes on the display may turn off after a 20 seconds, in that case the display will be blank.
Place the Machine Power / Engine Crank switch (25) on the operator console to the ON (center) position.Note: For this test procedure there is no need to sound the horn to activate RC or start the machine engine.
Press the "Engine Shutdown Switch" (34) on the "GLSC".Note: After performing this step, the action alarm on the console should activate. The "Active Fault LED" (43) should flash "RED" with every sound of the action alarm.Note: Along with the action alarm sounding the "EID: 678, Ground Level Shutdown Event" code will be raised.
Reset the "Engine Shutdown Switch" (34) on the "GLSC" by pulling out the switch.Note: Operator Console check is now complete.Refer to the Operation and Maintenance Manual, SEBU8453, "Preliminary Remote Console Checks" section within this manual for additional information to continue to activate RC.