PUMP-GEAR-YM 2260175 - Caterpillar

Parameter Descriptions
"Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Engine Serial Number"
The "Engine Serial Number" should be programmed to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."FLS" (Full Load Setting)
"FLS" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Change this value only if the engine is rerated or if a new ECM is installed. Factory passwords are required."FTS" (Full Torque Setting)
"FTS" is similar to "FLS". Change this value only if the engine is rerated or if a new ECM is installed. Factory passwords are required."Security System Immobilizer Installation Status"
This parameter allows the Machine Security System (MSS) to be disabled or removed. If the MSS is removed from the machine and this parameter is not programmed to "Not Installed", the engine will not start. Factory passwords are required."Engine Oil Weight"
Setting this parameter to the correct oil grade that is in the engine will aid in cold weather starting. Do not program this parameter to "Automatic Detection".Parameter Table
Table 1
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
"Equipment ID"     17 characters     blank     none    
"Engine Serial Number"     8 characters     blank     none    
"FLS"     -128 to +127     0     Factory    
"FTS"     -128 to +127     0     Factory    
"Security System Immobilizer Status"     "Installed" or "Not Installed"     Hardware Dependent (1)     Factory    
"Engine Oil Weight"     "0W20 oil grade"
"10W30 oil grade"
"15W40 oil grade"     "Automatic Detection"     none    
( 1 ) If the machine is equipped with MSS, the default installation status will be "Installed". If the machine is not equipped with MSS, the default installation status will be "Unavailable".Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Information from ECM    
"Equipment ID"    
   
"Engine Serial Number"    
   
"ECM Serial Number"    
   
"Personality Module Part Number"    
   
"Personality Module Release Date"    
   
"Personality Module Description"    
   
"FLS"    
   
"FTS"    
   
"Security System Immobilizer Status"    
   
"Engine Oil Weight"    
   
"Total Tattletale"    
   
Information From Engine Information Plate    
Engine Serial Number    
   
Full Load Setting
(for new ECM)    
   
Full Torque Setting
(for new ECM)    
   Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Change this value only if the engine is rerated or if a new ECM is installed. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.