PUMP GP-PISTON 2370292 - Caterpillar

Lever and Linkage Position Sensor Specific Calibration Errors
The following table lists error codes can be activated when performing either the Lever Position Sensor Calibrations or the Linkage Position Sensor Calibrations.
Table 1
Calibration Error Codes for Lever Or Linkage Position Sensors    
Error Code    Probable Cause of Activation    Recommended Actions    
10F0 - Calibration Out of Range Low     The linkage sensor or lever sensor duty cycle is lower than allowable calibration duty cycle range. This error can occur at the high or low end of the sensor full duty cycle range.     Check position sensor mechanical linkage. Ensure correct linkage sensor operation.
Lever / Joystick is not fully rearward.
Check for any external conditions or mechanical problem that could be preventing the implement arms from raising.    
10F1 - Calibration Out of Range High     The linkage sensor or lever sensor duty cycle is higher than allowable calibration duty cycle range. This error can occur at the high or low end of the sensor full duty cycle range.     Check position sensor mechanical linkage. Ensure correct linkage sensor operation.
Lever / Joystick is not fully forward.
Check for any external conditions or mechanical problem that could be preventing the implement arms from lower.
A lever or joystick could be above the normal duty cycle range. This condition will usually result in an active FMI 03 diagnostic code.    Solenoid Valve Specific Calibration Errors
The following table lists error codes can be activated when performing Solenoid Valve Calibrations.
Table 2
Calibration Error Codes for Solenoid Valve Calibrations    
Error Code    Probable Cause of Activation    Recommended Actions    
10F1 - Calibration Out of Range High     Current is ramped up to the solenoid and no movement is detected.     Check the solenoid for proper operation.
Check the hydraulic valve, lines, and connections for proper operation.
Check for any external conditions or mechanical problem that could be preventing proper operation.    General Calibration Codes
The following table lists error codes can be activated when performing any of the calibration procedures.
Table 3
General Calibration Error Codes    
Error Code    Probable Cause of Activation    Recommended Actions    
0002 - Active Diagnostic     An active diagnostic is preventing the calibration from being successfully performed.     Resolve the problem that is causing the