PUMP GP-BFT-YM 2423442 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of all maintenance which includes the following items: performing all adjustments , using proper lubricants, fluids, and filters and replacing old components with new components due to normal wear and aging .Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Choose the interval that occurs first in order to determine the correct maintenance interval: fuel consumption , service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. All of the following will affect the oil change interval: operating conditions , fuel type , oil type and size of the oil sump . Scheduled oil sampling analyzes used oil in order to determine if the oil change interval is suitable for your specific engine. Refer to this Operation and Maintenance Manual , "Engine Oil and Filter - Change" in order to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual , "Maintenance Recommendations" .When Required
Batteries - Replace
Cooling System Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element - Replace
Engine Oil - Change
Engine Oil Filter - Change
Overhaul Considerations
Valve Stem Projection - Measure/Record
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Control Panel - Inspect
Cooling System Coolant Level - Check
Driven Equipment - Inspect/Replace/Lubricate
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Clean
Engine Oil Level - Check
Fuel System Fuel Filter Differential Pressure - Check
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Every 250 Service Hours
Battery Electrolyte Level - Check
Engine Oil Sample - Obtain
Initial 1000 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Mounts - Check
Engine Speed/Timing Sensor - Clean/Inspect
Speed Sensor - Clean/Inspect
Valve Stem Projection - Measure/Record
Every 1000 Service Hours
Aftercooler Condensation - Drain
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Carburetor Air/Fuel Ratio - Check/Adjust
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Crankcase Breather - Clean
Engine Oil - Change
Engine Oil Filter (Auxiliary) - Change
Engine Oil Filter - Change
Engine Valve Lash and Bridge - Adjust
Engine Valve Rotators - Inspect
Exhaust Piping - Inspect
Gas Pressure Regulator - Check
Gas Pressure Regulator Condensation - Drain
Hoses and Clamps - Inspect/Replace
Ignition System Spark Plugs - Inspect/Replace
Ignition System Timing - Check/Adjust
Inlet Air System - Inspect
Radiator - Clean
Every 2000 Service Hours
Actuator Control Linkage - Lubricate
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant