PUMP GP-FUEL INJECTION 2679717 - Caterpillar

Performing the Dimension Measurements and Measure Up
Perform the calibration for the machine as listed in the specific section for your machine in "Performing the Calibrations".
Open the MCU.
Select the machine name.
Select Machine > Machine Dimensions. Enter the dimensions.
In the Menu Bar, select File > Send to Cat MineStar System.
Ask the Terrain Site Champion to send out a site-specific application file for the receiver.
Restart the on-board system and verify the accuracy of the receiver as follows:
Move the machine origin to a known point.
Compare the Northing, Easting, and Elevation. Performing the Calibrations
Enter correct details. Any errors transfer directly into the finished surface.
When a measurement refers to the phase center, the phase center is located 12.8 cm (5.0 inch) from the bottom of the receiver.
Illustration 27 g02980337
Measuring for the phase center (48)
( 10) 353-2794 Receiver
(48) Phase center Reference: Refer to "Machine Dimensions" in the MCU Help for the following steps:Calibrating Wheel Loaders
Illustration 28 g03099718
MCU screen shot of machine dimensions
Measure the machine GPS receiver offsets. Reference: Refer to the sample MCU screen shot, Illustration 28, as a reference guide and template to record the machine dimensions. Note: The "X" measurement that is taken to the right of the centerline of the machine will be a positive number. The "X" measurement that is taken to the left of the centerline of the machine will be a negative number. Note: