PUMP GP-FUEL TRANSFER 2712158 - Caterpillar

Removal Procedure
Start By:
Remove the fan. Refer to Disassembly and Assembly, "Fan - Remove and Install".
Remove the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Drain" for more information.
Loosen the hose clamp and disconnect the hose (not shown) from the water pump inlet.
Illustration 1 g01304930
Typical example
Illustration 2 g01305206
Typical example
Loosen hose clamps (5) and remove hose (6) from water pump (1) .
Remove bolt (3) and alternator bracket (2) from water pump (1) .Note: The alternator bracket on some engines is secured by two bolts.
Remove fasteners (7) and remove water pump (1) .Note: If necessary, gently tap the water pump with a soft faced hammer in order to loosen the water pump.
Remove joint (4) from the cylinder block.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the mating surfaces of the water pump and the cylinder block are clean and free from damage.
Illustration 3 g01304930
Typical example
Illustration 4 g01305206
Typical example
Install a new joint (4) to the cylinder block.
Place water pump (1) in position and install fasteners (7) finger tight.
Position alternator bracket (2) on the water pump. Install bolt (3) finger tight.Note: The alternator bracket on some engines is secured by two bolts.
For engines that have an alternator bracket that is secured by one bolt, tighten fasteners (7) to a torque of 10 N m (89 lb in).For engines that have an alternator bracket that is secured by two bolts, tighten fasteners (3) and (7) to a torque of 10 N m (89 lb in).
Connect the hose (not shown) to the water pump inlet and tighten the hose clamp. Install hose (6) on the water pump and tighten hose clamps (5) .
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Fill" for the correct procedure.End By:
Install the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Install the fan. Refer to Disassembly and Assembly, "Fan - Remove and Install".