PUMP GP-FUEL INJECTION 2823232 - Caterpillar

Attach the 12-pin connector (60) from the 249-9075 Harness (59) to the 12-pin connector on the machine wiring harness. Secure the harness with a tie strap (61) .
Illustration 35 g01322123
Attach the mounting plate to the radiator guard with the four 8T-4137 Bolts (62) and four 8T-4121 Hard Washers (63) .Installation of the Bracket for the Radio
O-Rops Installation
Note: The right rear flood lamp must be removed from the O-Rops in order to attach the mounting bracket onto the machine. The flood lamp will then be attached to the mounting bracket.
Illustration 36 g01322128
Remove the two bolts and washers (64) which secure the right rear flood lamp and the wiring harness for the flood lamp.
Illustration 37 g01322130
(65) 8T-4195 Bolts and 8T-4121 Hard Washers (66) 8T-4137 Bolt and 8T-4121 Hard Washer (67) 261-0170 Bracket As
Use two 8T-4195 Bolts and two 8T-4121 washers (65) to attach the 261-0170 Bracket As (67) to the O-Rops.
Attach the rear flood lamp to the 261-0170 Bracket As (67) with a 8T-4137 Bolt and a 8T-4121 Hard Washer (66) .E-Rops Installation
Illustration 38 g01322133
Remove two bolts (68) from the unit for the condenser. See Illustration 38.
Illustration 39 g01322134
The mounting bracket attached to the unit for the condenser with mounting hardware. (69) 261-0174 Bracket As (70) 163-5382 Spacer (71) 8T-4182 Bolt (72) 8T-4121 Hard Washer
Attach the 261-0174 Bracket (69) to the machine with two 8T-4182 Bolts (71), 8T-4121 Hard Washers (72), and 163-5382 Spacers (70). See Illustration 39.Note: Place the 163-5382 Spacer (70) between the machine and the 261-0174 Bracket (69) .Routing the 249-9071 Harness
Illustration 40 g01322144
View inside right hand side of the access door.
Connect the 12-pin connector that is part of the 249-9071 Harness to the available 12-pin connector (73). The connectors are located inside the right hand side access door. Refer to Illustration 40.
Illustration 41 g01322147
The 249-9071 Harness (74) is secured with 4P-7428 Clips (75) .
Install the harness (74) on the ROPS. See Illustration 41.
Secure the harness to the machine with using the 4P-7428 Clips (75) .Note: Mounting surfaces must be clean and dry for proper adhesive performance. Clean the surface with alcohol or equivalent solvent. Remove the protective backing from the clip. Place the clip in position. Apply pressure to the clip for one second. Use black electrical tape to wrap the wire bundle to the same diameter of the clip.Note: Leave the dust cap on the radio connector for protection.