PUMP 2F8427 - Caterpillar

Illustration 7 g00947759
Install two bolts (39), four washers (40), four washers (41), two nuts (42) and the two top half's of mounts (44). Tighten the nuts and bolts to a torque of 450 N m (332 lb ft).
Illustration 8 g00947710
Rear Cab Mounts
Illustration 9 g00947711
Install two bolts (34), two washers (35), two washers (36) and the two bottom half's of mounts (37). Tighten the bolts to a torque of 450 N m (332 lb ft).
Remove the lifting equipment.
Illustration 10 g00947701
Illustration 11 g00947702
At the underside of the cab, connect two electrical connectors (30) and tighten two bolts (29). Route positive cable (31) to the terminal block which is located on the side of the chassis which is near to the exhaust muffler. Install nut (32) and the washer in order to connect the positive cable to the terminal block. Install all cable straps and clips that were removed and noted in the removal procedure.
Illustration 12 g00947386
Connect two hoses (28) for the air conditioner (if equipped). Connect two heater hoses (27) and tighten the hose clamps. Install bolt (25) in order to connect cable (26) .
Illustration 13 g00947385
Route cable (20) from the cab to parking brake (24). Position bracket (23) onto parking brake (24) and install two bolts (22) and the washers. Align cable (20) with lever (21) and install pin (19) and clip (18). Install all cable straps and clips that were removed and noted in the removal procedure.
Illustration 14 g00947383
Route cable (14) from the cab to fuel pump (15). Install cable (14) into bracket (17) and tighten two nuts (16). Align the cable with the lever on the fuel pump and install pin (13). Install all cable straps and clips that were removed and noted in the removal procedure.
Illustration 15 g00947382
Install bolt (11) and the washer in order to connect ground strap (12) .
Illustration 16 g00947381
Connect hose (9) to metering pump (10). Connect hose (8) to the bottom of manifold (6) .
Illustration 17 g00947380
Connect tube (7) to manifold (6) and tighten the hose clamp. Connect four hoses (5) to the top side of the manifold.
Illustration 18 g00947371
Connect two hoses (2) to master cylinder (3). Connect tube (4) to the master cylinder and tighten the hose clamp.
Illustration 19 g00940864
Install cover (1) .
Fill the cooling system. The capacity of the cooling system is approximately 27.5 L (7.3 US gal). Refer to Operation and Maintenance Manual, SEBU7600, "Cooling System (ELC) - Change".
If equipped, charge the air conditioner system. The correct charge is 0.8 kg (1.8 lb). Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools".End By: Install the hydraulic tank. Refer to Disassembly and Assembly, "Hydraulic Tank - Install".