PUMP GP-GOV & FUEL INJ 2W8541 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-7470 Eyebolt 2
B - Forcing Screw
3/8 - 16 2
C 1P-0074 Puller Assembly 1 Start By:
Remove the dash panel. Refer to Disassembly and Assembly, "Dash Panel - Remove".
Remove the universal joint. Refer to Disassembly and Assembly, "Universal Joint - Remove and Install".
Remove the lubrication relief valve for the transmission. Refer to Disassembly and Assembly, "Transmission Lubrication Relief Valve - Remove and Install".
Remove the torque converter outlet relief valve. Refer to Disassembly and Assembly, "Relief Valve (Torque Converter Outlet) - Remove".
Remove the torque converter inlet relief valve. Refer to Disassembly and Assembly, "Relief Valve (Torque Converter Inlet) - Remove".
Remove the flywheel scavenge pump. Refer to Disassembly and Assembly, "Gear Pump (Flywheel Scavenge) - Remove". Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01305707
Disconnect tube assembly (1).
Illustration 2 g01303305
Illustration 3 g01303595
Remove tube assembly (2). Attach Tooling (A) and a suitable lifting device to torque divider (4). The weight of torque divider (4) is approximately 135 kg (298 lb). Remove nuts (3) that hold torque divider (4) to the flywheel housing.
Use Tooling (B) in order to separate torque divider (4) from the flywheel housing. Place a wire around carrier assembly (5) before torque divider (4) is removed from the machine. This will hold carrier assembly (5) in position when torque divider (4) is removed.
Illustration 4 g01303735
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove ring (6) and gear (7).
Illustration 5 g01303739
Remove springs (8). Remove ring (9).
Illustration 6 g01303741
Use Tooling (C) in order to remove bearing (10).