PUMP GP-FUEL INJECTION 2W9579 - Caterpillar

Two Camera Two Radar Configuration for Small Off-Highway Trucks
Note: The two cameras and two radar system is only available for the 775, 773, and 771. The system should NEVER be configured for two cameras and two radars if four cameras and four radars are installed.Note: The front and rear sensors are installed by default. The left and right sensors are configurable.Small Off-Highway Trucks may be configured as a two radars and two camera system. The following steps show how to set up this alternative configuration.
Illustration 1 g03375077
With CAT ET connected, select the "Object Detection System" then select the "Configuration Tool". Refer to Illustration 1.
Illustration 2 g03375079
Select the "Left Radar Sensor". Refer to Illustration 2
Illustration 3 g03375080
Change the "Installation Status" to "Not Installed". Refer to Illustration 3.
Complete Step 2 and Step 3 for the"Right Radar Sensor".
Illustration 4 g03375081
After selecting "Not Installed" for the left and right side radars, the same will need to be done for both side cameras. Select "Camera System" from the "Configuration Menu". Then select "Camera #2 Location" for the right side camera. Refer to Illustration 4.
Illustration 5 g03375082
Select "Not Installed" for "Camera #2 Location" as shown in Illustration 5.
Repeat Step 5 and Step 6 for the left side camera. The left camera is labeled "Camera #4 Location".
Illustration 6 g03375084
Verify both left and right camera "Value" is "Not Installed".
Restart the Object Detection System to save the changes.