PUMP & MTG GP-STEERING & FAN 3091652 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
(5/8 - 18 UNF by 8 1/2 inch) 1
Illustration 1 g01115663Note: Ring gear (3) must be installed with the chamfered side of the teeth upward. The chamfered side of the gear teeth will be facing toward the starting motor when the flywheel is installed.
Raise the temperature of ring gear (3). Install ring gear (3) on flywheel (2).
Install Tooling (A) in the crankshaft.
Use a suitable lifting device to support the flywheel. The weight of flywheel (2) is approximately 68 kg (150 lb). Position flywheel (2) on the crankshaft.
Apply clean engine oil to the threads of bolts (1).
Install bolts (1). Remove Tooling (A). Install one bolt (1).
Tighten bolts (1) to a torque of 270 40 N m (200 30 lb ft).
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".