PUMP GP-FUEL INJECTION 3176395 - Caterpillar

15. Disconnect wiring harness (33) and (34) at the electrical connections. 16. Remove four bolts (35) and the washers from clips (36). 17. Remove bolt (37) and the washer from clip (38). Disconnect wiring harness (33) at the electrical connections. 18. Disconnect hose assembly (40) from elbow (39). 19. Loosen two hose clamps (41) and (42) on hoses (43) and (44). Disconnect hoses (43) and (44). 20. Remove 11 tie straps (46) that hold wiring harness (45). Remove wiring harness (45) from engine (47). 21. Disconnect wiring harness (48) from the aftercooler temperature sensor at the electrical connection. Remove two bolts (50) and the washers from tube (51). Remove tube (51) and the O-ring seal from aftercooler (49). 22. Remove bolt (52) that holds bracket (53) to engine (47). 23. Disconnect tube assembly (54) from oil pan front section (55). 24. Remove two bolts (56) and the washers from oil level gauge (dip stick) (57). Remove oil level gauge (dip stick) (57) and the shaft gasket from oil pan front section (55). 25. Disconnect wiring harness (58) from the liquid level switch assembly at the electrical connection. 26. Remove eight bolts (59) and the washers from oil pan front section (55). 27. Position a suitable lifting device, (not shown), under oil pan (55). Remove 19 bolts (60) and the washers from oil pan (55). Remove oil pan front section (55) and the integral seal from engine (47).