PUMP GP-ENGINE OIL 3217355 - Caterpillar

HEIGHT=72>PI10103 This Program must be administered as soon as possible. When reporting the repair, use "PI10103" as the Part number and "7751" as the Group Number, "56" as the Warranty Claim Description Code and "T" as the SIMS Description Code. Exception: If the repair is done after failure, use "PI10103" as the Part Number, "7751" as the Group Number, "96" as the Warranty Claim Description Code, and "Z" as the SIMS Description Code.
PROBLEM
There is a wiring problem in the load door safety switch and the auto start/stop switch on XQ125, 200, and 300 dual wound generator packages. The problem is the wire placement in the eight-pin connector in the D.C. load pan wiring harness assembly. This connector attaches to the pigtail harness from the engine control panel. A potiential electrical shock hazard exists. When the load door is removed, it will not automatically shut off the circuit breakers. Another potential hazard is the loss of control to remotely start or stop the engine.
AFFECTED PRODUCT
Model Identification Number
3304B 9HK1000-1002, 1004-1009
3456 GHJ102, 120-121, 135-138
SR4 8GK1243-1256
3306B 8JJ1001-1017, 1020-1030
KAC133-146, KAC148-159PARTS NEEDED
None NeededACTION REQUIRED
See the attached Rework Procedure.
OWNER NOTIFICATION
U.S. and Canadian owners will receive the attached Owner Notification.
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts Labor Hrs. Parts Labor Hrs. Parts Labor Hrs.
0 1.0 0 0 0 0
This is a 1.0- hour job.
U.S. and Canadian Dealers Only - Eligible dealers may enter a Type 2 SIMS ReportPARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
Attach. (1-Owner Notification)
(2-Rework Procedure)
COPY OF OWNER NOTIFICATION FOR U.S. AND CANADIAN OWNERS
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
SAFETY - WIRING PROBLEM IN THE LOAD DOOR SAFETY SWITCH AND AUTO START/STOP SWITCH
MODELS INVOLVED - CERTAIN XQ125, 200, AND 300 DUAL WOUND GENERATOR PACKAGES
Dear Caterpillar Product Owner:
Adjustments need to be made on the products listed below. There is a wiring problem in the load door safety switch and the auto start/stop switch on XQ125, 200, and 300 dual wound generator packages. The problem is the wire placement in the eight-pin connector in the D.C. load pan wiring harness assembly. This connector attaches to the pigtail harness from the engine control panel. A potiential electrical shock hazard exists. When the load door is removed, it will not automatically shut off the circuit breakers. Another potential hazard is the loss of control to remotely start or stop the engine. You will not be charged for the service performed.
Contact your local Caterpillar dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service. Please refer the dealer to their Service Letter dated November 9, 2001 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed for your added safety and satisfaction.
Caterpillar Inc.
Identification #(s)
Attached to November 9, 2001 Service Letter
Rework Procedure
Turn battery disconnect switch to the "off" position and place "do not operate" or similar tag to the engine control switch on the control panel.
Remove the interior electrical bulkhead from the generator end of the enclosure assembly and set aside. (see photo #2)
On the