PUMP GP-GEAR 3414837 - Caterpillar

Dozer Blade Tilt
1. Pull the tilt lever left toward the operator to lower the left side of the blade.2. Push the tilt lever right away from the operator to lower the right side of the blade.To Adjust:
If additional tilt is required, the left brace may be adjusted. Shorten the brace to make left side of blade lower. Lengthen the brace to make the left side of blade higher.If the tilt brace length needs alteration, turn the handle to the left (counterclockwise), to lengthen it. Turn the handle to the right (clockwise), to shorten the brace. Lengthen the left brace and extend the right cylinder to tilt the blade forward. Shorten the left brace and retract the right cylinder to tilt the blade rearward.Ripper Tip and Shank Protector
Replace ripper tips or shank protectors before wear occurs on the shank. Follow the procedures given in the topic Ripper Tips and Shank Protector under When Required in the Maintenance Section of this manual.Tracks
If tracks are too tight or loose, wear of components is accelerated. If they appear too tight or too loose, adjust the track. Follow the adjustment procedures given in the topic Tracks under Every 250 Service Hours or Monthly in the Maintenance Section of this manual.
Cutting Edges and End Bits
Replace or reverse the cutting edges or end bits, before wear occurs on the blade base. Follow the replacement procedures given in the topic Cutting Edges and End Bits under When Required in the Maintenance Section of this manual.Winch Adjustment ("Inch" or "No-Inch")
The winch has an adjustable sequence valve, which permits the selection of either "no-inch" or "inching" characteristics, during reel out and reel in operations.Inching is the controlled movement of the cable during a reel out operation. The "inching" setting is generally used when the machine and winch are used for construction and pipeline work. This setting gives the operator the control necessary to put an object in an exact position.Where precise control is not necessary, as when logs are moved, the "no-inch" setting may be used.When using the inching setting, move the winch control lever to either the reel in or reel out channel. Move the lever into the channel to start drum rotation. Use the engine speed to control the inching rate. Always use a slower engine speed for better control when inching.The adjustable sequence valve, is set on the "inch" setting at the factory.To Adjust:
1. Remove winch access cover. 2. Remove the plug from the end of the valve. Use a screwdriver and turn the stop assembly. The slot in the stop assembly must be aligned with either the "inch" or "no-inch" mark. Install the plug in the end of the valve. Install the cover.