PUMP GP-METERING 3427430 - Caterpillar

Troubleshooting Procedures
Go to the procedure that corresponds to the CID and FMI that has been indicated. These procedures are used only for maintenance events (CID and FMI) that originate from the MSS. These procedures are used for CID's that have an MID of 436.If the MID is not for the MSS, see the Module Identifier chart on the Electrical System Schematic for the machine that is being serviced. Once you have determined the electronic control modules that detected the event, refer to the Service Manual for that control for troubleshooting information. The Service Manual modules for each control are part of the machine Service Manual.Diagnostic Codes
Table 2
Machine Security System (MID 124)
DTC Description Procedure
168-00 Electrical System Voltage : High Electrical Power Supply - Test
168-01 Electrical System Voltage : Low Electrical Power Supply - Test
248-12 Cat Data Link malfunction Cat Data Link - Test
1391-03 Theft Deterrent Output Driver #1 : Voltage Above Normal ECM Output Driver - Test
1391-04 Theft Deterrent Output Driver #1 : Voltage Below Normal ECM Output Driver - Test
1392-03 Theft Deterrent Output Driver #2 : Voltage Above Normal ECM Output Driver - Test
1392-04 Theft Deterrent Output Driver #2 : Voltage Below Normal ECM Output Driver - Test
5217-03 300mA Sourcing Driver Output #3 : Short to battery ECM Output Driver - Test
5217-04 300mA Sourcing Driver Output #3 : Short to ground ECM Output Driver - Test
5218-03 300mA Sourcing Driver Output #4 : Short to battery ECM Output Driver - Test
5218-04 300mA Sourcing Driver Output #4 : Short to ground ECM Output Driver - Test
5219-03 300mA Sourcing Driver Output #5 : Short to battery ECM Output Driver - Test
5219-04 300mA Sourcing Driver Output #5 : Short to ground ECM Output Driver - Test
5220-03 300mA Sourcing Driver Output #6 : Short to battery ECM Output Driver - Test
5220-04 300mA Sourcing Driver Output #6 : Short to ground ECM Output Driver - Test
247-9 J1939 Data Link Can Data Link - Test