3528589 PUMP GP-WATER Caterpillar parts
D9T
Rating:
Alternative (cross code) number:
CA3528589
352-8589
3528589
CA3528589
352-8589
3528589
Weight: 42 pounds 19 kg.
TRACK-TYPE TRACTOR,
Compatible equipment models: 3528589:
Information:
Illustration 1 g02026777
Schematic of the "Attachment Valve #1 Extend Pressure" solenoid
This diagnostic code is associated with the "Attachment Valve #1 Extend Pressure" solenoid. The FMI 06 diagnostic code means that the ECM has determined that the current of the solenoid is above normal.The possible causes of this diagnostic code are listed below:
The energizer circuit of the solenoid for the modulating valve is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1593 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active, the Machine ECM will turn off the current to the failed solenoid.Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:The CID 1593 FMI 06 diagnostic code changes to a CID 1593 FMI 05 diagnostic code when the solenoid is disconnected.Results:
YES - The CID 1593 FMI 06 diagnostic code changes to a CID 1593 FMI 05 diagnostic code when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid.STOP
NO - The CID 1593 FMI 06 diagnostic code remains active. Proceed to Test Step 2.Test Step 2. CHECK THE SOLENOID ENERGIZER CIRCUIT FOR A SHORT TO GROUND
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the Machine ECM.
At the machine harness connector, measure the resistance from the signal contact J2-38 (wire K856-PU(Purple)) to all contacts that are used in the machine harness connectors for the Machine ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-38 (wire K856-PU(Purple)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS
Inspect the harness connectors. Clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1593 FMI 06 diagnostic code. Expected Result:The CID 1593 FMI 06 diagnostic code is active.Results:
YES - The CID 1593 FMI 06 diagnostic code is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure
Caterpillar SIS machinery equipment:
Caterpillar parts catalog:
Parts pump Caterpillar catalog:
1981508
PUMP GP-ENGINE OIL
3406B, 3406C, 3406E, 3408, 365C, 365C L, 365C L MH, 374D L, 374F L, 375, 375 L, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L, 5080, 5090B, 583R, 587R, C-15, C-16, C15, C18, D8N, D8R, D...
3406B, 3406C, 3406E, 3408, 365C, 365C L, 365C L MH, 374D L, 374F L, 375, 375 L, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L, 5080, 5090B, 583R, 587R, C-15, C-16, C15, C18, D8N, D8R, D...
3848612
PUMP GP-FUEL TRANSFER
14M, 24M, 3406E, 3456, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 3512, 365C, 365C L, 365C L MH, 374D L, 374F L, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 5090B, 583T, 5...
14M, 24M, 3406E, 3456, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 3512, 365C, 365C L, 365C L MH, 374D L, 374F L, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 5090B, 583T, 5...
2243238
PUMP GP-WATER
385C, 385C FS, 385C L, 735, 740, C15, C18, D9T
385C, 385C FS, 385C L, 735, 740, C15, C18, D9T
2463132
PUMP GP-WATER
365C, 365C L, 365C L MH, 385C, 385C FS, 385C L, 385C L MH, 735, 740, C15, C18, D9T, TH35-C15T
365C, 365C L, 365C L MH, 385C, 385C FS, 385C L, 385C L MH, 735, 740, C15, C18, D9T, TH35-C15T
1908970
PUMP GP-FUEL PRIMING
120H, 120K, 120K 2, 12H, 12K, 135H, 140K, 140K 2, 140M, 14M, 160K, 160M, 16M, 24M, 3126B, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D L, 3...
120H, 120K, 120K 2, 12H, 12K, 135H, 140K, 140K 2, 140M, 14M, 160K, 160M, 16M, 24M, 3126B, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D L, 3...
7T8891
PUMP AS-WASHER
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...