PUMP GP-AUXILIARY SEA WATER 3550325 - Caterpillar

General Information for Roading
Before you road a machine, consult your tire dealer for recommended tire pressures and for speed limitations.Limitations for load/speed rate must be obeyed. Consult your tire dealer for the speed limit of the tires that are used.When you travel for long distances, schedule stops in order to allow the tires and the components to cool. Stop for 30 minutes after every 40 km (25 miles) or stop for 30 minutes after every hour.Inflate the tires to the correct air pressure.Use a self-attaching inflation chuck and stand behind the tire tread during the inflation. Refer to Operation and Maintenance Manual, "Tire Inflation - Check".Perform a Walk-Around Inspection and measure the fluid levels in the various compartments.Check with the proper officials in order to obtain the required licenses and other similar items.Learn and obey all traffic regulations when you are roading the machine. Travel at a moderate speed. Observe all speed limitations when you road the machine. Ensure that the hydraulic system is locked out. Ensure that all work tools remain securely attached to the work tool coupler. Ensure that appropriate locking pins remain in position. Ensure that the machine meets all local requirements. Ensure that all roading decals are visible. Replace any decal that is damaged. Ensure that all necessary equipment for roading the machine is installed. The necessary equipment can be obtained from your local Caterpillar Dealer.Roading in Germany and Italy
Complete all of the following operations that are applicable to your machine before you road the machine.Verify that all lights are in proper working order.Turn on the roading lights when you are roading the machine.Lift Arm
In Germany, place the lift arm and the work tool in the roading position.Note: In Italy, perform the following procedure in order to place the lift arm and the work tool in the roading position.
Enter the machine. Fasten the seat belt. Start the engine.
Disengage the parking brake.
Illustration 1 g01384819
Raise the lift arms approximately 200 mm (7.9 inches) from the parked position. Tilt back the work tool.
Stop the engine. Set the parking brake and exit the machine.
Insert the lift arm brace on the rod end of the lift cylinder. Insert the pin and secure the pin with the clip. Note: The flange on the brace must face the rear of the machine.
Enter the machine. Fasten the seat belt. Turn the ignition key to the On position. Do not start the engine.
Slowly lower the lift arm onto the brace.
Exit the machine.
Illustration 2 g01384826
Install the strap for restraining the tilt cylinder.
Do not attempt to tilt the work tool forwards with the restraining strap in place. Do not move the lift arms down while the brace is installed. Damage to the machine or damage to the equipment could occur.
Tighten the strap with the ratchet. Secure the loose end of the strap. Mirrors
If necessary, adjust the mirrors.Rotating Beacon Light
Illustration 3 g03805558
(1) Beacon In Italy, install the rotating beacon light on top of the cab. Insert the plug into the receptacle on the top front on the left side