PUMP GP-WATER 3561246 - Caterpillar

Every Week or Every Two Weeks
Note: Because of varying conditions, only actual experience in a particular application can dictate the adequate amount of maintenance.Cleaning:
Remove the buildup of corrosive material by washing the machine with cold water. Use low water pressure with a maximum pressure of 100 Bars.
Use compressed air in order to dry the machine completely.Greasing:When the machine is completely dry, immediately perform the following:
Apply grease to all other articulated areas. Refer to the Operation and Maintenance Manual for the machine.
Apply grease to the hood actuator of the 924K, 930K, and 938K.
Apply grease or spray oil in any area with friction.Inspect:
Fuse Box
Inspect the inside of the fuse box.
Apply 151-1340 Dielectric Grease on all fuses.
Apply 4C-9612 Silicone Sealant to all unsealed connector terminals.
Other electrical connections
Inspect other sealed connections for damage or rust.
Inspect other unsealed connections for damage or rust, and repair with 4C-9612 Silicone Sealant . Use the following repair procedure in order to repair the connectors.
Paint Inspect the paint over the entire machine for damage. Use the following process to repair the paint if the paint is damaged:
Sand the damaged area with sandpaper.
Remove dust and degrease the surface.Note: Refer to Sigma Coatings Reference numbers for paint.
Apply a layer of the 4C-4190 Yellow Primer Paint . Allow the paint to dry for 8 hours.
Apply a layer of yellow polyurethane 4C-4184 Yellow Paint . Allow the paint to dry for 8 hours.Use steps 1 through 4 whenever the following conditions exist:
Parts are disassembled for repair or disassembled for maintenance.
The original coating is damaged or scratched by tools and handling.
Any attachments are added to the machine after shipment.The following items are available through the