PUMP AS 3728868 - Caterpillar

Basic Engine (T2R)
Table 6
Status (1)     Description     Specification     Actual     Comments    
    Engine Speed at High Idle     2205 10 rpm            
    Engine Speed at Low Idle     600 10 rpm            
    Cylinder Cutout Test     -         Caterpillar Electronic Technician    
    Engine Crankcase Blowby     -            
( 1 ) N = Normal, M = Monitor, A = ActionAir Inlet and Exhaust System
Table 7
Status (1)     Description     Specification     Actual     Comments    
    Air Filter Indicator     -            
    Closed Crankcase Ventilation (CCV) Indicator     -            
( 1 ) N = Normal, M = Monitor, A = ActionElectrical System
Table 8
Status (1)     Description     Specification     Actual     Comments    
    Inspect Battery Cables     Cables between the battery, the starter, and the engine ground must be the correct size. Wires and cables must be free of corrosion. Wires and cables must have cable support clamps in order to prevent stress on battery connections (terminals).            
    Battery Test (2)     12.4 VDC or more            
    Charging System Test (3)     18 VDC to 32 VDC            
    Electric Starting System Test (4)     12 to 16 V at
−23° C (−10° F) to
−7° C (19° F)            
14 to 18 V at
−7° C (19° F) to
10° C (50° F)
16 to 24 V at
10° C (50° F) to
27° C (80° F)
( 1 ) N = Normal, M = Monitor, A = Action
( 2 ) Refer to Special Instruction, SEHS7633, "Battery Test Procedure".
( 3 ) Refer to Special Instruction, REHS0354, "Charging System Troubleshooting".
( 4 ) Refer to Testing and Adjusting, RENR9808, "Electric Starting System - Test".S.O.S
Table 9
Status (1)     Description     Obtain     Comments    
    Engine Oil Sample            
    Engine Coolant Sample (Level II)            
    Hydraulic Oil Sample            
    Transmission Oil Sample            
    Right Final Drive Oil Sample            
    Left Final Drive Oil Sample            
( 1 ) N = Normal, M = Monitor, A = Action