PUMP GP-WATER 3744753 - Caterpillar

(11)Rear Suspension Cylinder
Lubricate 4 fittings.(12)Rear Axle Housing Lateral Control Rod
Lubricate 2 fittings.(13)King Bolt
Lubricate 2 fittings.(14)Hitch Yoke
Lubricate 1 fitting.(15)Rear Axle Housing A-Frame
Lubricate 1 fitting.(16)Steering Follow-Up Linkage
Lubricate 5 fittings.(17)Steering Tie Rods, Arm Pin Bearing And Trailing Unit Control Bellcrank
Lubricate 5 fittings. Lubricate 2 fittings.(18)Front Suspension Cylinder Rods
Lubricate 1 fitting on each side.(19)Fan Adjusting Pulley And Water Pump (768)
Lubricate 4 fittings.(20)Belt Adjustment (768)
1. Check condition and adjustment of belts. Correct adjustment of alternator belts, allow 9/16 to 13/16 inch (14 to 20 mm) deflection. 2. To adjust, loosen locknut. 3. Turn adjusting nut to obtain correct deflection. Tighten locknut.(21)Belt Adjustment (772)
1. Check condition and adjustment of belts. Correct adjustment allows 9/16 to 13/16 inch (14 to 20 mm) deflection. 2. To adjust, loosen locknut. 3. Turn adjusting nut to obtain correct deflection. Tighten locknut.(22)Front Wheel Brake Lining
1. Apply brakes. (Front wheel brake control must be in ON position) and check for clearance between edge of shoe plates and retractor springs. Install new brake lining when shoe plate contacts retractor springs. 2. Have damaged or missing retractor springs replaced.(23)Front Wheel Brake Oil Reservoir
Remove plug and check oil level. Maintain oil level to FULL mark on plunger gauge.(24)Engine Crankcase
1. On 768, remove cover and element. 2. On 772, loosen hose clamp, remove cover and elements.
When using pressure air, wear safety face shield and protective clothing. Use 30 PSI (2 kg/cm2) maximum pressure air for cleaning purposes.
3. Wash elements in clean solvent and dry. 4. Install elements and cover.(25)Steering Hydraulic System
1. Remove filter cover, used element and screen. 2. Inspect cover seal. Use new seal if necessary. 3. Wash screen in solvent.4. Install new element.