PUMP GP-UNIT INJECTOR HYD 3840607 - Caterpillar

Crank Terminate Speed
This parameter determines the engine rpm that the starting motors will disengage.
Table 10
Minimum Default Maximum
100 rpm 400 rpm 500 rpm Air Shutoff
Programming the parameter to "OFF" will disable the air shutoff. Program this parameter to "OFF" if the function is not being used or installed on this engine. This will prevent diagnostics from being logged.
Table 11
Minimum Default Maximum
OFF OFF ON Ether Control
Programming this parameter to "OFF" will disable the function. Program this parameter to "OFF" if the function is not being used or installed on this engine. This will prevent diagnostics from being logged.
Table 12
Minimum Default Maximum
OFF OFF ON Engine Cooling System
This parameter determines the configuration of the cooling system. This parameter requires a factory password to change.
Table 13
Minimum Default Maximum
SCAC SCAC JWAC Fuel Correction Factor
The parameter is programmed to a numerical value. The calculations will be adjusted in accordance with the numerical value. The parameter requires a factory password to change.Cat Data Link
This parameter determines the engine identification for the secondary Cat Data Link.
Table 14
Minimum Default Maximum
Engine Control 1 Engine Control 1 Engine Control 8 Cold Mode Cylinder Cutout
This parameter provides the ability to enable the cold mode cylinder cutout.
Table 15
Minimum Default Maximum
Disabled Disabled Enabled Direct Fuel Control Mode
If you program the parameter to "ON", you will enable the direct fuel control mode. The parameter requires a factory password to change. This feature requires special hardware in order to operate properly.
Table 16
Minimum Default Maximum
OFF OFF ON Injector Trim Code
Note: The injector trim code is not part of the "Configuration" screen on Cat ET. "Injector Codes Calibration" can be found under "Calibrations" in the "Service" menu on Cat ET.The injector trim code is a number that is found on each of the unit injectors. The ECM uses this number to compensate for manufacturing variations between individual injectors. If you replace any of the unit injectors, you must reprogram the injector trim codes for the new injectors. Also, if you replace the ECM, you must reprogram all of the injector trim codes.
Table 17
Injector Trim Code
Injector Default Range Password
"Inj #1 e-trim" 0000 4 numeric characters No
"Inj #2 e-trim" 0000 4 numeric characters No
"Inj #3 e-trim" 0000 4 numeric characters No
"Inj #4 e-trim" 0000 4 numeric characters No
"Inj #5 e-trim" 0000 4 numeric characters No
"Inj #6 e-trim" 0000 4 numeric characters No
"Inj #7 e-trim" 0000 4 numeric characters No
"Inj #8 e-trim" 0000 4 numeric characters No
"Inj #9 e-trim" 0000 4 numeric characters No
"Inj #10 e-trim" 0000 4 numeric characters No
"Inj #11 e-trim" 0000 4 numeric characters No
"Inj #12 e-trim" 0000 4 numeric characters No
"Inj #13 e-trim" 0000 4 numeric characters No
"Inj #14 e-trim" 0000 4 numeric characters No
"Inj #15 e-trim" 0000 4 numeric characters No
"Inj #16 e-trim" 0000 4 numeric characters No