AVSPARE.COM
parts catalog

PUMP GP-FUEL TRANSFER 3919625 - Caterpillar


3919625 PUMP GP-FUEL TRANSFER Caterpillar parts 314E LCR
Rating:
27
Alternative (cross code) number:
CA3919625
391-9625
3919625
Caterpillar 3919625 PUMP GP-FUEL TRANSFER

Buy PUMP GP-FUEL TRANSFER 3919625 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 3919625:

EXCAVATOR  314E LCR   Caterpillar
  For full view, you need register

Information:


Illustration 1 g00891909
Schematic of the suspension cylinder pressure sensors
This diagnostic code is associated with the left rear suspension cylinder pressure sensor. This diagnostic code is recorded when the Payload Measurement Control (PMC) determines that the signal from the sensor is not valid and/or there is no output from the sensor. The possible causes of this diagnostic code are listed below:
The sensor has failed.
The signal wire is open.
The signal wire is shorted to ground.
The signal wire is shorted to other circuits in the machine harness.
The signal wire is shorted to the +battery circuit.
The Payload Measurement Control (PMC) has failed. This is unlikely.Use this procedure to troubleshoot the suspect performance of suspension cylinder pressure sensors or any failure that is associated with the suspension cylinder pressure sensors.Note: This test checks for sensor voltages at the sensor when all the circuits are connected. You should not disconnect any electrical connectors, unless you are directed to disconnect a connector in the procedure that is provided below. Troubleshoot the diagnostic code before disconnecting any circuits. Disconnecting the sensor from the harness before measuring the voltage may alter a poor connection. This will make the proof of cause difficult or impossible.Locate the suspect sensor. Identify the sensor wires and connector contacts. DO NOT DISCONNECT ANY HARNESS CONNECTORS AT THIS TIME. Turn the key start switch to the ON position. It is recommended that the engine be shut off, unless it is necessary for the engine to be running. The truck can be empty or the truck can be loaded.Test Step 1. CHECK THE SENSOR SUPPLY VOLTAGE.
At the sensor connector, identify the +V and ground circuits.
Insert the 7X-1710 Multimeter Probe leads into the back of the sensor's connector along side of +V and ground circuit wires.
Measure the system voltage. Expected Result:The voltage is between 22.0 DCV and 29.5 DCV.Results:
YES - The voltage is between 22.0 DCV and 29.5 DCV. The system voltage is present. proceed to test step 2.
NO - The voltage is less than 22.0 DCV. The circuit is not correct. Repair: Trace the +V and ground circuits in the machine harness. Repair the machine harness or replace the machine harness. If the machine harness has not failed the sensor is the cause of the failure. Replace the sensor. A failed sensor is unlikely.STOPTest Step 2. CHECK THE SENSOR SIGNAL VOLTAGE.
At the sensor connector, identify the signal and ground circuits.
Insert the 7X-1710 Multimeter Probe leads into the back of the sensor's connector along side of the signal and ground circuit wires.
Measure the signal voltage. Expected Result: The signal voltage is between approximately 1.0 DCV and 5.0 DCV. Results:
The voltage is greater than 5.0 DCV - The signal voltage is not correct. Proceed to test step 3.
The voltage is less than 1.0 DCV. - The signal voltage is not correct. Proceed to test step 4.
The voltage is between 1.0 DCV and 5.0 DCV - The signal circuit is correct. Proceed to test step 5.Test Step 3. CHECK THE SIGNAL CIRCUIT FOR A SHORT TO

Caterpillar parts catalog:

Caterpillar parts catalog
314E LCR Excavator DKD00001-UP (MACHINE) POWERED BY C4.4 Engine


Parts pump Caterpillar catalog:

3494069 PUMP GP-GEAR
311D LRR, 311F LRR, 312D, 312D L, 312D2, 312E, 312E L, 313D, 314D CR, 314D LCR, 314E CR, 314E LCR, 315D L, 316E L, 318E L, 319D L
3421891 PUMP & MTG GP-AUXILIARY
311D LRR, 311F LRR, 312D, 312D L, 312D2, 312E, 312E L, 313D, 314D CR, 314D LCR, 314E CR, 314E LCR, 315D L, 316E L, 318E L, 319D L
3337914 PUMP GP-WATER
312E, 312E L, 314E CR, 314E LCR, 316E L, 318E L, C4.4, C4.4XQ100, C4.4XQ80, CB-44B, CB-54B, CP-54B, CP-68B, CP-74B, CS-54B, CS-56B, CS-64B, CS-66B, CS-76B, CS-78B, CW-34
3494068 PUMP & MTG GP-MAIN HYDRAULIC
312E, 312E L, 314E CR, 314E LCR
3529451 PUMP GP-MAIN HYDRAULIC
312E, 312E L, 314E CR, 314E LCR
3607507 PUMP GP-FUEL INJECTION
312E, 312E L, 314E CR, 314E LCR, 316E L, 318E L, C4.4, CP-54B, CP-68B, CP-74B, CS-54B, CS-56B, CS-64B, CS-66B, CS-76B, CS-78B, CW-34
3594002 PUMP AS-METERING
312E, 312E L, 314E CR, 314E LCR, 316E L, 318E L, 416F, 420F, 428F, 430F, 432F, 434F, 444F, 450F, C4.4, C4.4XQ100, C4.4XQ80, CB-44B, CB-54B, CP-54B, CP-68B, CP-74B, CS-54B, CS-56B, CS-64B, CS-66B, CS-7...
4179305 PUMP AS-WATER
312E, 312E L, 314E CR, 314E LCR, 316E L, 318E L, 320E L, 320E LN, 320E LRR, 323E L, C4.4, C4.4XQ100, C4.4XQ80, CB-44B, CB-54B, CP-54B, CP-68B, CP-74B, CS-56B, CS-66B, CS-76B, CS-78B, CW-34
3708364 PUMP
312E, 312E L, 314E CR, 314E LCR, 316E L, 318E L, C4.4, CP-54B, CP-68B, CP-74B, CS-54B, CS-56B, CS-64B, CS-66B, CS-76B, CS-78B, CW-34
3576475 PUMP AS-FUEL TRANSFER
2570C, 2670C, 312E, 312E L, 314E CR, 314E LCR, 316E L, 318E L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 563C, 573C, 924K, 950K, 962K, BG1000E, C7...
3687702 PUMP GP-FUEL TRANSFER
311F LRR, 312E, 314E LCR, 316E L, 318E L
3914811 PUMP GP-FUEL INJECTION
323D2 L, 535D, 545D, 924K, 930K, 938K, 950 GC, C7.1, D6K2
3752647 PUMP GP-FUEL INJECTION
323D2 L, 535D, 545D, 924K, 930K, 938K, 950 GC, C7.1, D6K2
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.