3G3897 PUMP GP-METERING Caterpillar parts
120G, 12G, 130G, 140G
Rating:
Alternative (cross code) number:
CA3G3897
3G-3897
3G3897
CA3G3897
3G-3897
3G3897
Weight: 16 pounds 7 kg.
MOTOR GRADER,
Information:
below.Undervoltage - Generator voltage is less than specified for too long a time.Overexcitation - The measured field current is too high for too long a time.When a fault occurs, the digital voltage regulator automatically flashes the corresponding fault code on the display and takes the necessary preventive action. For shutdown faults, the digital voltage regulator disables the output to the exciter. While a fault is present, the fault code information shown on the display will be flashing. If a shutdown fault occurs, the shutdown fault MUST BE RESET in order for the digital voltage regulator to begin operation again. The method to reset a shutdown fault depends upon the classification of the fault. When a fault code is reset, the display will stop flashing. The digital voltage regulator will begin generator output regulation again, according to generator/engine speed and the mode selected. For more information, see System Operation, "Fault Classifications".Fault code 601 - Internal Memory Failure. This fault is an alarm fault. The EEPROM failed during a read action.Note: Reset the fault. Clear the fault. If the alarm reoccurs, check all parameter values between 1 and 38 by using the function keys on the face of the digital voltage regulator or remote communications. This refreshes the programmed values and should eliminate the alarm condition. If the alarm persists, verify that proper grounding, shielding, and electromagnetic noise reduction practices have been followed in the installation before replacing the digital voltage regulator.Fault code 602 - Internal Watchdog Failure. This fault is an alarm fault. A microprocessor watchdog is intended to detect when the microprocessor gets "lost" and to restart the microprocessor again. The watchdog alarm indicates that the digital voltage regulator just came out of a watchdog-induced microprocessor restart.Note: A possible cause is electro magnetic interference (EMI). It may be necessary to provide shielded cable, grounded on one end, for all potentiometers. Another possible cause is the battery voltage being too low (less than 18 VDC). See watchdog alarm, fault code 602. Refer to Testing And Adjusting, "Watchdog Alarm - Troubleshoot".Fault code 603 - Rotating Diode. Check the diodes as per the generator service manual. This fault is a resettable shutdown fault. The digital voltage regulator detects that the variation (ripple) of exciter field current exceeds the diode monitor trip point (parameter :19) for a period of five seconds. A large variation in the exciter field current will occur if a rotating diode fails, shorted or open. This may also occur with good diodes under varying loads if the diode monitor trip point is set too low (too sensitive).Note: For troubleshooting purposes it is useful to know that this alarm fault is often followed by an overexcitation shutdown fault. If an overexcitation shutdown fault (fault code 703) is found in parameter :92, check parameter :93 (or the alarm parameter :95 if it exists) for the presence of the rotating diode monitor alarm code.Fault code 604 - Reverse VAR (only available on 155-xxxx and later regulators). This fault is an alarm
Caterpillar SIS machinery equipment:
Caterpillar SIS
120G MOTOR GRADER 11W01019-01250 (MACHINE) POWERED BY 3304 ENGINE »
3G-3897
PUMP GP-METERING
130G MOTOR GRADER 12W00696-01081 (MACHINE) POWERED BY 3304 ENGINE »
3G-3897
PUMP GP-METERING
140G MOTOR GRADER 13W00425-00740 (MACHINE) POWERED BY 3306DI ENGINE »
3G-3897
PUMP GP-METERING
120G MOTOR GRADER 82V00668-UP (MACHINE) POWERED BY 3304 ENGINE »
3G-3897
PUMP GP-METERING
130G MOTOR GRADER 74V00588-01656 (MACHINE) POWERED BY 3304 ENGINE »
3G-3897
PUMP GP-METERING
130G MOTOR GRADER 12W00001-00695 (MACHINE) POWERED BY 3304 ENGINE »
3G-3897
PUMP GP-METERING
12G MOTOR GRADER 61M02629-07710 (MACHINE) POWERED BY 3306 ENGINE »
3G-3897
PUMP GP-METERING
140G MOTOR GRADER 72V00823-04230 (MACHINE) POWERED BY 3306 ENGINE »
3G-3897
PUMP GP-METERING
12G MOTOR GRADER 61M07711-12026 (MACHINE) POWERED BY 3306 ENGINE »
3G-3897
PUMP GP-METERING
140G MOTOR GRADER 72V04231-10333 (MACHINE) POWERED BY 3306 ENGINE »
3G-3897
PUMP GP-METERING
130G MOTOR GRADER 74V01657-02058 (MACHINE) POWERED BY 3304 ENGINE »
3G-3897
PUMP GP-METERING
120G MOTOR GRADERS 87V05275-08359 (MACHINE) POWERED BY 3304 ENGINE »
3G-3897
PUMP GP-METERING
Caterpillar parts catalog:
Parts pump Caterpillar catalog:
1052508
PUMP AS-FUEL PRIMING
120G, 12G, 12H, 12H ES, 12H NA, 140H, 140H ES, 140H NA, 143H, 14H, 14H NA, 160H, 160H ES, 160H NA, 163H, 163H NA, 16G, 16H, 16H NA, 214B, 235, 3114, 3116, 3126, 3126B, 3126E, 3176, 3176B, 3176C, 3196,...
120G, 12G, 12H, 12H ES, 12H NA, 140H, 140H ES, 140H NA, 143H, 14H, 14H NA, 160H, 160H ES, 160H NA, 163H, 163H NA, 16G, 16H, 16H NA, 214B, 235, 3114, 3116, 3126, 3126B, 3126E, 3176, 3176B, 3176C, 3196,...
1375541
PUMP GP-FUEL PRIMING
120G, 12G, 130G, 140G, 140H, 143H, 14G, 14H, 160G, 160H, 163H, 1673C, 16H, 235B, 24H, 3116, 311C, 311D LRR, 3126, 3126B, 3126E, 312C, 312C L, 312D, 312D L, 313D, 314C, 314D CR, 314D LCR, 315C, 315D L,...
120G, 12G, 130G, 140G, 140H, 143H, 14G, 14H, 160G, 160H, 163H, 1673C, 16H, 235B, 24H, 3116, 311C, 311D LRR, 3126, 3126B, 3126E, 312C, 312C L, 312D, 312D L, 313D, 314C, 314D CR, 314D LCR, 315C, 315D L,...
1898777
PUMP GP-ENGINE OIL
120H, 120H ES, 120H NA, 120K, 120K 2, 12K, 12M, 135H, 135H NA, 140G, 140K, 140K 2, 140M, 160K, 30/30, 3116, 3126, 3126B, 3126E, 320B, 322B L, 322B LN, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L,...
120H, 120H ES, 120H NA, 120K, 120K 2, 12K, 12M, 135H, 135H NA, 140G, 140K, 140K 2, 140M, 160K, 30/30, 3116, 3126, 3126B, 3126E, 320B, 322B L, 322B LN, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L,...
6N6800
PUMP AS-FUEL PRIMING
120G, 215, 815B, 943, 955L, 963, 966D, AP-1000B, D5B
120G, 215, 815B, 943, 955L, 963, 966D, AP-1000B, D5B
4N2511
PUMP ASSEM.
120G, 140B, 140G, 235, 245, 3406, 3412, 920, 930, 941, 966C, D35HP, D400, D4D, D5B, D6C, D6D
120G, 140B, 140G, 235, 245, 3406, 3412, 920, 930, 941, 966C, D35HP, D400, D4D, D5B, D6C, D6D
7T8891
PUMP AS-WASHER
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, ...
0R0920
PUMP GP-ENGINE OIL
12H, 140G, 140H, 140H NA, 143H, 160H, 235B, 330, 330B L, 572R, 611, 615C, 627B, 627F, 815F, 966F, 966F II, 972G, D250E II, D6H, D6H XL, D6H XR, D6R, D7G, D7H, D7R
12H, 140G, 140H, 140H NA, 143H, 160H, 235B, 330, 330B L, 572R, 611, 615C, 627B, 627F, 815F, 966F, 966F II, 972G, D250E II, D6H, D6H XL, D6H XR, D6R, D7G, D7H, D7R
3E5470
PUMP AS-WASHER
120H ES, 120H NA, 12H ES, 12H NA, 130G, 135H NA, 140H, 140H ES, 140H NA, 143H, 14H NA, 160H ES, 160H NA, 163H NA, 16H NA, D7G
120H ES, 120H NA, 12H ES, 12H NA, 130G, 135H NA, 140H, 140H ES, 140H NA, 143H, 14H NA, 160H ES, 160H NA, 163H NA, 16H NA, D7G
9T1802
PUMP GP-GEAR
120G, 14G, 16G
120G, 14G, 16G
0R1005
PUMP GP-WATER
12H, 140G, 140H, 140H NA, 143H, 160H
12H, 140G, 140H, 140H NA, 143H, 160H
0R1004
PUMP GP-WATER
140G, 143H, 160H
140G, 143H, 160H
6W4816
PUMP GP-VANE
IT18
IT18
1563436
PUMP GP-HAND
DEUCE
DEUCE
1403494
PUMP GP-ADDITIVE SPRAY
CP-433C, CS-431C
CP-433C, CS-431C
3645381
PUMP GP-GEAR
PL83
PL83
4E8719
PUMP & MOUNTING GP
65, 75
65, 75
5I7973
PUMP GP-WATER
320, 320 L, 320B, 320B FM LL, 320B U, 320N
320, 320 L, 320B, 320B FM LL, 320B U, 320N