PUMP GP-GEAR 3T0300 - Caterpillar

Pressure Regulating System
Illustration 1 g00287035
Pressure regulating valve (1) Adjustment screw. (2) Regulator inlet. (3) Regulator outlet.Check and adjust the pressure regulating valve by using the following procedure:
Drain the line to the pressure regulating valve or drain the air storage tank.
Disconnect the regulator from the starter control valve.
Connect the 8T-0849 Pressure Gauge Group to the regulator outlet (3) .
Put air pressure in the line or the tank.
Check the pressure.
Adjust the pressure regulating valve to the following value:Outlet pressure ... 621 to 758 kPa (90 to 110 psi)
Remove the air pressure from the line or the tank.
Remove the 8T-0849 Pressure Gauge Group and connect the air pressure regulator to the line to the air starting motor.Each engine application must be inspected in order to provide the most acceptable results when the engine is started. The following factors affect the settings for the pressure regulating valve:the load that is pulled by the attachments on the engine, ambient temperature conditions, oil viscosity, capacity of air reservoir and condition of the engine.The advantage of setting the valve at the higher pressures is the increased torque for the starting motor and the faster rotation of the engine. The advantage of setting the valve at the lower pressures is the longer time of the engine rotation for the given reservoir capacity of the supply air.Lubrication
Always use an air line lubricator with the air starting motors that have vanes.For temperatures above 0°C (32°F), use a good quality SAE 10 nondetergent oil.For temperatures below 0°C (32°F), use air tool oil. To maintain the efficiency of the starting motor, flush the starting motor at regular intervals. Pour approximately 0.5 L (0.53 qt) of diesel fuel into the air inlet of the starting motor and operate the starting motor. This procedure will remove the following items from the vanes of the air starting motor.
dirt
water
oilAir Starting Motor
Illustration 2 g00544840
Rear view of the cylinder and rotor for clockwise rotation (typical example) (1) Cylinder. (1A) Air inlet passages. (1B) Dowel hole. (2) Rotor.The cylinder (1) must be assembled over the rotor (2) and on the front end plate (14). The dowel hole (1A) and the inlet passages (1B) are for the air. If the installation is not correct, the starter drive (10) will turn in the wrong direction.Tighten the bolts (16) of the rear cover in small increases of torque. Tighten all bolts until the bolts are tight 25 to 35 N m (18 to 25 lb ft).
Illustration 3 g00544842
Air starter (Ingersoll-Rand) (typical example) (1) Cylinder. (2) Rotor. (3) Air inlet. (4) Gear case. (5) Drive gear. (6) Grease seal. (7) Drive shaft collar. (8) Drive housing. (9) Drive shaft. (10) Starter drive (pinion). (11) Mounting flange on the drive housing. (12) Bolt. (13) Gear case cover. (14) Front end plate. (15) Deflector (air outlet). (16) Bolt.Apply a thin layer of lubricant on the lip of the seal (6) and on the outside of the collar (7). This lubricant is for the installation of the drive shaft (9). After the installation of the shaft through