PUMP AS 4575834 - Caterpillar

Operation Description:If the frequency rises above the generator over frequency percentage threshold set point value, then the over frequency timer will begin timing. When the timer expires, the generator over frequency event is made active (if the frequency has been above the threshold level continuously while timing). If the frequency rises above the generator over frequency percentage threshold, then the generator over frequency event will be made inactive. The timer will be reset.If an over frequency condition is detected, then "GEN OVERFREQUENCY SHUTDOWN" or "GEN OVERFREQUENCY " will be displayed on the EMCP 3. The message is used to inform the operator of an over frequency condition.Note: The severity of the over frequency condition will determine if a warning or shutdown event occurs.The code for generator over frequency is generated when the EMCP 3 determines that a generator over frequency condition has occurred.Test Step 1. TALK TO THE OPERATOR.
Determine the conditions that caused the over frequency condition.Expected Result:An over frequency condition was caused by an occurrence that is known to the operator. The operator would like to put the generator set back into service.Results:
OK - The operator can determine the cause for the over frequency condition. The condition has been repaired, and the operator wants to put the generator set back into service.Repair: Reset the generator set. Resume normal operation and verify that the problem has been corrected.STOP
NOT OK - The over frequency condition was not caused by an occurrence known to the operator. Proceed to Test Step 2.Test Step 2. CHECK THE SET POINTS.
View the generator over frequency and generator desired engine speed request set points. Make a note of the set points. See Testing and Adjusting, RENR7902, "Electronic Control Module (Generator Set) - Configure". Compare the set points against the default set points of the particular generator set.Expected Result:The set points are correct.Results:
OK - The set points are correct for your particular generator set. Proceed to Test Step 3 for EUI engines. Proceed to Test Step 4 for MUI engines.
NOT OK - The set points are NOT correct.Repair: Reprogram the set points. Reset the generator set. Resume normal operation and verify that the problem has been corrected.STOPTest Step 3. VERIFY FREQUENCY CAN BE VIEWED AND ADJUSTED FROM THE EMCP 3 (EUI ENGINES ONLY)Verify that the