PUMP AS-FUEL INJECTION 4656106 - Caterpillar

Table 33
Value    Default    
Installed
Not Installed     Installed    User-Defined Switch Installation Status
A user-defined shutdown switch is an optional switch input. Programming the "User Defined Switch Installation Status" parameter to "Enabled" notifies the ECM that a user-defined switch input is present. If this parameter is programmed to "Enabled" and the user-defined shutdown switch closes, the engine will shut down.
Table 34
Value    Default    
Installed
Not Installed     Not Installed    Auxiliary Temperature Sensor Installation Status
An auxiliary temperature sensor is an optional input. Programming the "Auxiliary Temperature Sensor Installation Status" parameter to "Enabled" notifies the ECM that an auxiliary temperature sensor input is present.
Table 35
Value    Default    
Installed
Not Installed     Not Installed    Auxiliary Pressure Sensor Installation Status
An auxiliary pressure sensor is an optional input. Programming the "Auxiliary Pressure Sensor Installation Status" parameter to "Enabled" notifies the ECM that an auxiliary pressure sensor input is present.
Table 36
Value    Default    
Installed
Not Installed     Not Installed    Fuel Filter Differential Pressure Switch Configuration
A fuel filter differential pressure switch is an optional input. Programming the "Fuel Filter Differential Pressure Switch Configuration" parameter to "Normally Open" or "Normally Closed" notifies the ECM that a fuel filter differential pressure switch input is present.
Table 37
Value    Default    
Not Installed
Normally Open
Normally Closed     Not Installed    J1939 Continuous Fault Handling
Remote Torque Speed Control Enable Status
The Remote Torque Speed Control Enable Status parameter controls the type of remote TSC input. If this parameter is "Enabled", the ECM expects a continuous signal from TSC1. If this parameter is "Disabled", the ECM expects an intermittent signal from TSC1.
Table 38
Value    Default    
Enabled
Disabled     Enabled    System Settings
System Operating Voltage Configuration
The System Operating Voltage Configuration parameter is the operating voltage for the engine electrical system.
Table 39
Value    Default    
12 VDC
24 VDC     12 VDC    Passwords
Customer Password 1
The Customer Password 1 is the first security password that can be defined by the customer.
Table 40
Value    Default    
Eight alphanumeric characters     Eight spaces    Customer Password 2
The Customer Password 2 is the second security password that can be defined by the customer.
Table 41
Value    Default    
Eight alphanumeric characters     Eight spaces    Security Access Parameters
CAN Communication Protocol Write Security
The CAN Communication Protocol Write Security parameter control the security required for writing information through the CAN bus.
Table 42
Value    Default    
Seed and Key
No Security     Seed and Key    CAN Communication Protocol Read Security
The CAN Communication Protocol Read Security parameter control the security required for reading information from the CAN bus.
Table 43
Value    Default    
Seed and Key
No Security     Seed and Key