PUMP GP-PISTON & GEAR 4876185 - Caterpillar

Illustration 1 g00510982
The service technician can select the desired "ESET" configured event by scrolling through the list of events. The service technician uses the "<" and ">" arrow keys on the keypad in order to scroll. Note: The Master Event Number is a unique number that is assigned to an event. The Master Event Number is listed in the "Data Event Report" for a given configuration. The "Master Event Number" is viewed with the Caterpillar Information System Builder. This report can be generated by selecting the "data event report" option under the "Navigate Menu" of the "Information System Builder". The numbers are listed in the "MST EVNT (Master Event)" column of the report.
Illustration 2 g00511040
(1) Master event number
(2) Event storage function
(3) Event display function
(4) Service indicator lamp
(5) Telemetry System
(6) Factory default function
(7) Status of the function
(8) Name of event
The service technician can select the desired function from the following list by pressing the corresponding "number key". The "X" indicates that the function has been enabled. The "-" indicates that the function has been disabled. The definition of the functions are listed here:Event Storage function (2) toggles the status of the function from an "X" to a "-" in order to indicate that the function has been disabled. Event Display function (3) toggles the status of the function from an "X" to a "-" in order to indicate that the function has been disabled. Service indicator Lamp (4) toggles the status of the function from an "X" to a "-" in order to indicate that the function has been disabled. Telemetry (Broadcast) function (5) toggles the status of the function from an "X" to a "-" in order to indicate that the Telemetry (Broadcast) function has been disabled. Factory Default function (6) toggles the status of the function from an "X" to a "-" in order to indicate that the Factory Default function has been enabled or that the Factory Default has been disabled. See the Notes.Note: All configurable events are set to the factory defaults that are designated in the configuration software until the default is changed by performing this procedure.Note: The ESET command references the functions as the function has been setup in the configuration. The ESET command can turn OFF a function ONLY when the function is turned ON in the configuration software. The ESET command will NOT allow a function that is disabled from the factory in the configuration software to be turned ON.Procedure
To set the "EVENT DISPLAY" function, press the "2" key. The following message will be displayed on the message center.
Illustration 3 g00511120
Illustration 4 g00552273
The "> arrow" key is used to toggle the status of the "EVENT DISPLAY" ON and OFF. Press the "OK" key in order to accept the change. The message center will then display the current Master Event Number message. Refer to Illustration 4. If the "X" is selected then the message center will display the event. If the "-" is selected the message center will NOT display the event.Use this procedure