PUMP GP-FUEL INJECTION 5297865 - Caterpillar

Illustration 1 g01455712
Typical exampleNote: All bores must be free of paint. Use the 5P-0960 Grease Cartridge in order to coat all bores for the pins, the bucket and the cylinder pin bores. (1) As required, use the following shims to adjust the maximum lateral clearance to 1.6 mm (0.06 inch): 093-0065 Shim Quantity ... 12 Thickness of one shim ... 1.0 mm (0.04 inch) 099-7091 Shim Quantity ... 6 Thickness of one shim ... 1.5 mm (0.06 inch) 093-0097 Shim Quantity ... 6 Thickness of one shim ... 2.0 mm (0.08 inch) (2) Torque for the four bolts ... 70 15 N m (50 11 lb ft) (3) Lubricate the sealing lip of the four lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install the four lip type seals so that the lip type seals do not extend beyond the face of the boss. (4) 1R-6224 Pin As Pin diameter ... 59.86 0.03 mm (2.357 0.001 inch) Bore diameter of view A-A for the pin assembly ... 60.00 to 61.00 mm (2.362 to 2.402 inch) Bore diameter of view B-B for the pin assembly ... 75.00 to 75.03 mm (2.953 to 2.954 inch) (5) 273-6945 Sleeve Bearing Quantity ... 2 Inside diameter ... 60.15 0.04 mm (2.368 0.002 inch) Outer diameter ... 75.085 0.010 mm (2.9561 0.0004 inch) Installation depth of the sleeve bearing ... 10.0 0.8 mm (0.39 0.03 inch)