PUMP AS-WATER 5404708 - Caterpillar

Illustration 1 g03694590The battery disconnect switch is outside of the operator station behind the access cover on the left side of the machine.
Illustration 2 g03701492
Turn the battery disconnect switch to the ON position.
Illustration 3 g01416287
Move direction selector (1) to the NEUTRAL position.
Engage the parking brake (2).
Turn engine start switch key (3) to the ON position. The monitoring system performs an automatic self test. The action alarm sounds and all of the indicator lights come on briefly. The indicator light for the parking brake will stay on. If the implement controls are locked out, the indicator light for the implement lockout will stay on. The indicator light for the auto kickdown will stay on until the function is unselected. The indicator light for the parking brake stays on until parking brake switch (2) is released. The indicator light for the implement lockout stays on until implement lockout switch (4) is turned off.
Turn engine start switch key (3) to the START position. Crank the engine. Release the key when the engine starts.
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result if the engine rpm is not kept low until the oil gauge display verifies that the oil pressure is sufficient.
Ether Starting Aid
If engine coolant temperature is below 0 °C (32 °F) and the machine is operating at sea level, the engine ECM will automatically inject ether during engine cranking and during engine warm-up. The duration of ether increases with colder temperatures at start-up.If the machine is operating in areas of high altitude, the coolant temperature threshold for injecting ether is increased. (For example at an altitude of 2440 m (8000 ft), when the coolant temp is below 9° C (48° F) ether will be injected.)
Manually spraying Ether into an engine with a Diesel Particulate Filter (DPF) may result in the accumulation of Ether in the DPF and an explosion. This in conjunction with other factors may result in an injury or death.
The system is automatic. Manual operation of ether starting system is not permitted. Do not introduce any additional ether into the inlet air system. The additional ether may damage the engine.For starting below −18°C (0°F), the use of the cold weather starting aids is recommended. A fuel heater, a jacket water heater, and extra battery capacity may be required.At temperatures below −23°C (−10°F), consult your Cat dealer. For information on starting the engine in cold weather, refer to the Operation and Maintenance Manual, SEBU5898, "Cold Weather Recommendations for all Caterpillar Machines".