PUMP AS-HYDRAULIC 5456062 - Caterpillar

Removal Procedure
Start By:
Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install" for the correct procedure.
Remove the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Remove" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02895676
Remove banjo bolt (2) and piston cooling jet (1) from the cylinder block.
Repeat Step 1 in order to remove the remaining piston cooling jets. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g02895676
Clean the piston cooling jets and inspect the piston cooling jets for damage. Replace any damaged piston cooling jets. The procedure for checking that the alignment of the piston cooling jets is described in Specifications, "Piston Cooling Jet Alignment".
Install banjo bolt (2) to piston cooling jet (1). Install the piston cooling jet assembly into the recess in the cylinder block.
Tighten banjo bolt (2) to a torque of 18 N m (159 lb in).
Repeat Step 2 through Step 3 for the remaining piston cooling jets. End By:
Install the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Install" for the correct procedure.
Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Install" for the correct procedure.