PUMP G. 6F0025 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 390-1146 Crankshaft Rear Seal and Wear Sleeve Driver(1) 1
423-9665 Crank shaft Rear Seal and Wear Sleeve Driver(2) 1
(1) Used for the C3.3B
(2) Used for the C2.6Note: Refer to Specification UENR0995 "Engine Design" for non-specified engine Torque Values.
Illustration 1 g02800138
Place wear sleeve (4) on crankshaft gear (2). Position Tooling (A). Use a suitable press and install wear sleeve (4).
Illustration 2 g02799899
Align crankshaft gear (2) with camshaft gear (3). Install crankshaft gear (2) into the flywheel housing.
Illustration 3 g02800140
Apply clean engine oil on the lip of crankshaft rear seal (1). Use Tooling (A) in order to install crankshaft rear seal (1). End By:
Install the flywheel.