PUMP GP-FUEL INJECTION 7W9468 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     2P-8250     Strap Wrench As     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01312956
Use Tooling (A) to remove secondary fuel filter (4) .
Disconnect hose assemblies (1) .
Remove bolts (2) and remove base assembly (3) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     2P-8250     Strap Wrench As     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 2 g01312956
Position base assembly (3) and install bolts (2) .
Connect hose assemblies (1) .
Use Tooling (A) to install secondary fuel filter (4) .
Prime the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime".