PUMP GP-FUEL INJECTION 8N2515 - Caterpillar

the factory is 400 rpm. The value is selectable from 100 to 1000 rpm in increments of 10 rpm. P12 Oil Step Speed - This setpoint tells the GSC the engine speed to use for distinguishing between rated speed and idle speed when a low oil pressure fault exists. The fifth character of the model number specifies this setpoint. The default setting from the factory is 1350 rpm. The value is selectable from 400 to 1800 rpm in increments of 10 rpm.
Table 2
Oil Step Speed    
Engine Family     Rated Speed (rpm)     Setpoint (rpm)    
3600     1000     760    
900 660    
750 560    
720 540    
3500     1000-1300     810    
1500-1900 1210    
3400 with 113 flywheel teeth (1)     1000-1600     760    
1750-1800 1140    
3400 with 136 flywheel teeth     1000-1200     760    
1500 1130    
1800-2100 1360    
3300     1400-1800     1130    
3208     1500-2800     1330    
3116     1500-2800     1330    
3114     1500-2800     1330    
( 1 ) Exception: For 3412 engines with 113 flywheel teeth and a rated speed of 1500 or 1600 rpm, the oil step speed in 1360 rpm.P13 Low Oil Pressure Shutdown At Rated Speed - This setpoint tells the GSC when to declare that a low oil pressure shutdown fault exists with the engine at rated speed. The engine speed must have exceeded the oil step speed for nine seconds. The fifth character of the model number specifies this setpoint. The default setting from the factory is 205 kPa (30 psi). The value is selectable from 34 to 420 kPa (5 to 60 psi) in increments of one.Note: When oil pressure drops to within 34 kPa (5 psi) of the P13 setpoint, an oil pressure alarm is issued by the GSC and the optional alarm module.P14 Low Oil Pressure Shutdown At Idle Speed - This setpoint tells the GSC when to declare that a low oil pressure shutdown fault exists with the engine at idle speed. The engine must have been running for at least nine seconds, and the engine speed must be less than the oil step speed. The fifth character of the model number specifies this setpoint. The default setting from the factory is 70 kPa (10 psi). The value is selectable from 20 to 336 kPa (3 to 50 psi) in increments of one.Note: When oil pressure drops to within 34 kPa (5 psi) of the P14 setpoint, an oil pressure alarm is issued by the GSC. When oil pressure is greater than the P14 setpoint, the GSC activates the EGR K1 relay. The GSC then tells the electronic governor to go to rated speed. When oil pressure is less than the P14 setpoint, the GSC deactivates the EGR K1 relay. The GSC then tells the electronic governor to go to idle speed.P15 High Water Temperature Shutdown - This setpoint tells the GSC when to declare that a high