PUMP & MOUNTING GP 8R9589 - Caterpillar

Connection Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 439-3939 Link Bracket As. 1
B 1P-3532 Track Block Assembly 1
C - Loctite Graphite-50 -
Place the track under the machine. Lower the side of the machine onto the track.
Remove a carrier bolt. Install Tooling (A) to the final drive carrier. Attach a chain to Tooling (A). Attach the chain to the track. Align the chain with the top of the carrier roller and the idler. Rotate the final drive in the reverse direction. The final drive will pull the track onto the final drive. Remove the bolt from the carrier and remove the chain.
Illustration 1 g00866469
Lift the end of the track and place Tooling (B) under the track.
Turn the final drive in the reverse direction in order to pull the track together.Note: Make sure that the serrations on the master links are clean and dry.
Illustration 2 g00866482
Align the lower ends of the master links with the upper ends. Make sure that the serrations of both ends are engaged.
Illustration 3 g00866497
Place the master shoe in position on the master links. Apply Tooling (C) to the threads and to the shaft of the master link bolts. Tighten the master link bolts to a torque of 400 70 N m (295 52 lb ft). Then, tighten the master link bolts by an extra turn 120 5 degrees.
c
Illustration 4 g00820219
Tighten relief valve (2) and tighten track adjustment valve (3) to a torque of 34 7 N m (25 5 lb ft).
Tighten the track. Refer to Testing and Adjusting, "Track - Adjust"
to tighten the track.
Illustration 5 g00820599
Install track adjuster cover (1) to the track roller frame.