PUMP G. 9F4447 - Caterpillar

Illustration 1 g01458188
From the Home menu, press the Down/Right button or press the Left/Up button until "Payload" is highlighted.
Press the "OK" button.
Illustration 2 g01458251
From the Payload menu, press the Down/Right button or press the Left/Up button until "View Reports" is highlighted.
Press the "OK" button.
Illustration 3 g01458253
From the "Payload: View Reports" menu, press the Down/Right button or press the Left/Up button until either "Current Operator" or "Current Shift" is highlighted.Note: A menu of the two types of reports are displayed on the Advisor. The two types of reports are listed below:"CURRENT OPERATOR""CURRENT SHIFT"Both of these reports will be similar in appearance. These reports will display the same categories of information. However, each report will summarize a different time period. These reports are updated with each truck load when the operator presses a Payload Store button. The reports are not updated at each individual bucket load.
Press the "OK" button.
Illustration 4 g01458256
Press the Down/Right button or press the Left/Up button in order to toggle between screens.The reports contain the following information:
"Total Weight"
"Truck Count"
"Weight / Hour"
"Fuel / Hour"
"Weight / Fuel"
"Average Truck Load Time"
"Average Delay Time"
"Average Cycle Time"
"Average Bucket Payload"
"Average Truck Payload"The periods of time that are covered by each of the reports are described in the following sections. "Current Operator Report"The report for the current operator contains all the payload information that has been stored for the current operator. When a new operator identification is entered, all of the "productivity information" for the current operator is reset to zero.
Table 1
Report     Start     Stop    
Current Operator     First store under current operator identification     Current time    Report for Current ShiftThere are two shifts that are defined in the system. The shifts are listed in the Table 2.
Table 2
Shifts     Start     Stop    
First shift     06:00     18:00    
Second shift     18:00     06:00    The report for the "current shift" represents all of the payload information with the following characteristics:
Stored
Active during the most recent shiftThe "shift times" are defined in the configuration software. The "shift times" should not overlap. When a new shift becomes active, all of the productivity information for the current shift is reset to zero. The report for the current day represents all payload information.