PUMP GP-GEAR 9J5763 - Caterpillar

Illustration 1 g00110215
(1) Manual circuit breaker reset, (2) Maintenance indicator lamp, (3) Diagnostic lamp, (4) Warning lamp, (5) Automatic circuit breaker reset , (6) Maintenance clear switch, (7) Emergency stop button, (8) Service hour meter and (9) Start switch
The standard control panel has the following features:
Manual Circuit Breaker Reset
Maintenance Indicator Lamp
Diagnostic Lamp
Warning Lamp
Automatic Circuit Breaker Reset
Maintenance Clear Switch
Emergency Stop Button
Service Hour Meter
Start SwitchThe control panel is mounted to the side of the engine that is used for service of the engine.Circuit Breaker Reset - There are three circuit breaker resets that are located within the control panel: two automatic circuit breaker resets (15 amp) and one manual circuit breaker reset (15 amp). Check the circuit breaker reset if there is a total loss of electrical power to the engine.Maintenance Indicator Lamp (2) - This lamp will flash when scheduled maintenance needs to be performed. Diagnostic Lamp (3) - This lamp will flash when a diagnostic code has been generated by the Electronic Control Module (ECM). The active diagnostic code will flash.Warning Lamp (4) - This lamp will flash when a critical condition has occurred such as low oil pressure or high coolant temperature.Maintenance Clear Switch (6) - After the appropriate maintenance has been performed to the engine, the maintenance clear switch is pushed in order to clear the maintenance indicator lamp.Emergency Stop Button (7) - The OUT position is for normal engine operation. Push the emergency stop button in order to stop the engine during an emergency. The start switch will not energize the starting motor magnetic switch while the emergency stop button is depressed. The emergency stop button must be reset before the engine can be started. Turn the emergency stop button clockwise in order to release and allow start-up.Service Hour Meter (8) - The service hour meter monitors the service hours of the engine. The service hour meter will operate only when the engine is running.Start Switch (9) - The start switch has three positions: OFF, RUN and START. When the start switch is turned clockwise to the RUN position, the lamps will flash for five seconds during the system test. The lamps will then shut off. In the RUN position, the ECM and electronic systems are powered up.When the switch is turned to the START position, the starting motor magnetic switch is energized. The electric starting motor is engaged. The starting motor will continue to crank while the start switch is held in the START position. The start switch is spring loaded in order to return to the RUN position when the start switch is released. The engine may be shut down by turning the start switch to the OFF position. This mode of shutdown removes power to the ECM.