PUMP G.-TRANSM 9M8284 - Caterpillar

Illustration 2 g03391645
With Tooling (B) and the suitable lifting device still supporting the engine and transmission install bolt (28). Tighten bolt (28) to a torque of 900 100 N m (664 74 lb ft). Repeat for the opposite side.
Illustration 3 g03391643
Use two people to install mount assembly (27). The weight of mount assembly (27) is approximately 25 kg (55 lb). Install bolts (26) and (25). Tighten bolt (26) to a torque of 900 100 N m (664 74 lb ft). Repeat for the opposite side.
Illustration 4 g03391490
Illustration 5 g03391515
Remove Tooling (B). Disconnect the suitable lifting device from lift points (24). Disconnect the suitable lifting device from Tooling (B) and Tooling (A). Remove Tooling (B) and Tooling (A).
Illustration 6 g03391481
Connect cable assemblies (21). Connect hose assembly (22). Connect clamp (23).
Illustration 7 g03391453
Connect hose assembly (17) and (18). Connect clamps (19) and (20).
Illustration 8 g03391417
Connect hose assemblies (16).
Illustration 9 g03391413
Connect fill tube (15).
Illustration 10 g03391409
Connect hose assembly (14) .
Illustration 11 g03391402
Connect hose assembly (13).
Illustration 12 g03391397
Connect tube assemblies (11). Connect clamp (12).
Illustration 13 g03391386
Connect three hose assemblies (8) and the cable strap assemblies to the transmission. Connect clamps (9). Connect clamps (10) .
Illustration 14 g03391347
Connect hose (7).
Illustration 15 g03391372
Connect hoses (5). Connect ground strap (4). Install sensor assembly (6).
Illustration 16 g03391327
Install platform (1) and bolts (3). Install bolts (2).
Fill the power train oil. Refer to Operation and Maintenance Manual, "Power Train Oil - Change" for the correct filling procedures.End By:
Install the steering valve.
Install the center drive shaft.
Install the rear drive shaft.
Install the power train guard.
Install the crankcase guard.
Install the clean emissions module.
Install the hydraulic tank.