PUMP GP-AUXILIARY WATER 9Y8909 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-9200     Lever Puller Hoist     1    
B     138-7575     Link Bracket     3    
C     189-0409     Shackle As     2    
D     1P-2420     Transmission Repair Stand     1    
E     -     Forcing Bolt
1/2 - NC 13 by 3 inches     2    Start By:
Remove the transfer gears. Refer to Disassembly and Assembly, "Transfer Gears - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all harness assemblies, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01289637
Use Tooling (A), Tooling (B), Tooling (C), and a suitable lifting device in order to position torque converter housing (1) on Tooling (D). The weight of the torque converter and torque converter housing (1) is approximately 590 kg (1300 lb).
Illustration 2 g01289639
Illustration 3 g01289640
Illustration 4 g01289642
Attach Tooling (B) to torque converter (2). The weight of torque converter (2) is approximately 365 kg (805 lb).
Remove bolts (3) .
Use Tooling (E), Tooling (B), and a suitable lifting device in order to remove torque converter (2) from the housing.
Illustration 5 g01289643
Remove O-ring seal (4) .