PUSHROD 2043355 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0510     Driver Group     1    
Make sure that all parts are thoroughly clean prior to assembly. Apply clean SAE 30 oil to all parts.
Illustration 1 g00321551
Install two locating dowels in oil pump manifold (4). The correct assembled height of the locating dowels is 5 0.5 mm (0.20 0.020 inch).
Install O-ring seal (7) .
Illustration 2 g00844353
Oil Pump Manifold
Use Tooling (A) to install two sleeve bearings (8) in oil pump manifold (4). Install the bearings into the bores so that the bearings are 1.5 0.5 mm (.06 .02 inch) below the surface. Install the bearings so that the bearing joints are 30 15 degrees from the centerlines of the shafts, as shown.
Illustration 3 g00321550
Install pump gear assembly (6) .
Illustration 4 g00321549
Install pump drive gear assembly (5) in oil pump manifold (4) .
Illustration 5 g00844353
Oil Pump Manifold
Use Tooling (A) to install two sleeve bearings (3) in oil pump cover assembly (2). Install the bearings into the bores so that the bearings are 1.50 0.50 mm (.06 .02 inch) below the surface. Install the bearings so that the bearing joints are 30 15 degrees from the centerlines of the shafts, as shown.
Illustration 6 g00321547
Install oil pump cover assembly (2) .
Illustration 7 g00321546
Install six bolts (1) in oil pump cover assembly (2). The torque for bolts (2) is 55 10 N m (41 7 lb ft).End By: Install the transmission oil pump. Refer to Disassembly and Assembly, "Transmission Oil Pump - Install".