RACE 1655857 - Caterpillar

Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.
This warning label is located on the electric masts. The warning label is placed to the rear of the masts at eye level.
Illustration 1 g01069921
Warning decal that is located on the electric masts
To prevent possible personal injury during installation and removal of the laser receivers, lower the mast to the minimum height and use an approved access system to reach the mounting locations of the laser receivers at the top of the mast. Do not climb on the blade.
Once the system is placed in automatic mode, blade movement may occur.Ensure that all personnel are clear of the blade before you place the system in automatic mode.Personal injury or death from crushing could occur.
This warning label is located on the tripod. The label is placed in a location on each leg of the tripod in order to be easily seen.
Illustration 2 g01073304
Warning decal that is located on the legs of the laser transmitter
Movement of the transmitter could cause unexpected blade movement. Death or serious injury could occur. Turn off the transmitter before you move the transmitter or before you adjust the transmitter.
Safety (Laser)
The IEC and the United States Government Center of Devices for Radiology Health (CDRH) has classified this laser as a Class II laser product. The maximum radiant power output of this laser is less than 5 milliwatts.Refer to the operator's manual of the laser transmitter for installation and operating instructions.The laser that is supplied with the AccuGrade - Laser System complies with all applicable portions of "Title 21" of the "Code of Federal Regulations, Department of Health and Human Services, Food and Drug Administration, Federal Register, Volume 50, Number 161, 20August 1985".This laser complies with "OSHA Standards Act, Section 1518.54" for use without eye protection. Eye protection is not required or recommended. The following safety rules should be observed:
Never look into a laser beam or point the beam into the eyes of other people. Set the laser at a height that prevents the beam from flashing directly into people's eyes.
Do not remove any warning signs from the laser.
Use of this product by personnel that are not trained on this product may result in exposure to hazardous laser light.
If initial service requires the removal of the outer protective cover, removal of the cover must be performed by trained personnel.Crushing Prevention and Cutting Prevention
Support the equipment properly when you work beneath the equipment. Do not depend on the hydraulic cylinders to hold up the equipment. An attachment can fall if a control is moved, or if a hydraulic line breaks.Unless you are instructed otherwise, never attempt adjustments while the machine is moving. Also, never attempt adjustments while the engine is running. Whenever there are attachment control linkages, the clearance in the