RACE & ROLLER ASSEM. 2D6419 - Caterpillar

Always inspect lifting eyebolts and all other lifting equipment for damage before performing any lifting. Never bend the eyebolts and the brackets. Never perform product lifting if components are damaged. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Read all the information within product lifting before any lifting is attempted. Ensure that the correct set of lifting eyes for the assembly to be lifted have been selected.Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the assembly. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted.Engine and Clean Emission Module (CEM)
Illustration 1 g03051657
Typical example
(1) Lifting eyes for engine and aftertreatment.Refer to illustration 1 for the location of the lifting eyes to lift the assembly.CEM Only
Ensure that the exhaust inlet for the CEM is not damaged during removal and installation. Do not allow the weigh of the CEM to act on the exhaust inlet.
Illustration 2 g03051677
Typical example
(2) Lifting eyes for the CEMRefer to illustration 2 for the location of the lifting eyes to lift the CEM. The lifting eyes (2) are designed only to lift the CEM. The lifting eyes (2) must not be used to lift any other parts of the application.Note: If the CEM is removed from the application, the inlet and outlet connections must be protected to prevent damage.Pump Electronics Tank Unit (PETU) Only
The tank on the PETU should be empty before the assembly is lifted.
Illustration 3 g03419909
Typical example
(3) Lifting eyes for PETURefer to illustration 3 for the location of the lifting eyes to lift the PETU.Engine Only
Illustration 4 g03051679
Typical example
(4) Lifting eyes for the engineRefer to illustration 3 for the location of the lifting eyes to lift the engine.Engine CEM and Radiator
Illustration 5 g06157681
(5) Lifting locationThe engine CEM and radiator are mounted on a frame. This entire package can only be lifted using suitable fork lift tines. Refer to illustration 5 for the fork lift tine locations.