RACE-BEARING-YM 4162170 - Caterpillar

Illustration 1 g00291770
Track roller frame (1) Pivot shaft housing (2) Access port for track adjustment cylinder (3) Recoil oscillation guide (4) Seal (5) Front roller frame (6) Rear roller frame (7) Shims
Illustration 2 g00291774
Front section of track roller frame (8) Valves (9) Cylinder (10) Piston (11) Retainer (12) Recoil SpringThe track roller frame can be separated into two sections. Front section (5) has a large tube assembly that telescopes or slides into rear roller frame (6). Recoil spring (12) is inside this tube. A groove is machined in the outer diameter of the tube. Recoil oscillation guide (3) is installed in rear roller frame (6). After installation, the oscillation guide is in alignment with the groove in the tube.The oscillation guide prevents any rotation of the tube inside the rear section of the roller frame. The guide allows the tube to move back and forth in the frame section during recoil. Seal (4) keeps the oil in the compartment. Also, the seal keeps out dirt.
Grease is under high pressure.Grease coming out of the relief valve under pressure can penetrate the body causing injury or death.Do not watch the relief valve to see if grease is escaping. Watch the track or track adjustment cylinder to see if the track is being loosened.Loosen the relief valve only one turn.
Valves (8) are used for moving the front roller frame in order to adjust the track. When grease is pumped into the filler valve, this causes piston (10) to move in a forward direction. This movement causes the front roller frame to move out of the rear roller frame.The movement of the recoil rod and the front idler tightens the track. Tension on the track is released by a relief valve.Shims (7) allow the height of the front idler to be adjusted for different machine applications.