RACE 7H2241 - Caterpillar

Illustration 1 g00803848
Schematic for the Tilt Lever Position SensorThis diagnostic code is recorded when the implement electronic control module (ECM) determines that the signal for the tilt lever position sensor is too low. The lift lever position sensor is a pulse width modulated sensor.The possible causes for this diagnostic code are listed:
The tilt lever sensor rotated below the calibrated operating range.System Response:The machine response is listed:
If the diagnostic code is active for at least three seconds, then the 353-13 diagnostic code will become active. The 353-01 diagnostic code will become inactive.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected. Note: Ensure that the diagnostic code is active.Test Step 1. CHECK THE ALIGNMENT OF THE LEVER POSITION SENSOR
Check the mounting hardware for the lever position sensor. The fasteners should be tight. If the sensor shows any signs of damage the hardware should be replaced.
Check the duty cycle of the lever position sensor. In order to measure the duty cycle of the sensor, use a 9U-7330 Digital Multimeter with a 7X-1710 Probe Group. At the implement ECM, use contact J2-5 and contact J1-15. Move the control lever to the full travel in both directions.Expected Result:The duty cycle should be between 10% and 90%.Results:
YES - The duty cycle is correct.Repair: Calibrate the lever position sensor. Stop.
NO - The duty cycle is not correct.Repair: Replace the lever position sensor. Calibrate the new sensor. Check for an active code. Stop.