2D1659 RACK Caterpillar parts
140
Rating:
Alternative (cross code) number:
CA2D1659
2D-1659
2D1659
CA2D1659
2D-1659
2D1659
Weight: 82 pounds 37 kg.
MOTOR GRADER,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
29 Apr 2018
8219 Hundredths Pounds
CTP: CTP
Caterpillar RACK CENTER SHAFT(CIRCLE (2D1659)
2D1659 Caterpillar Weight(lbs): 82.00 Length(cm): 127.0000 Width(cm): 35.6000 Depth(cm): 30.5000
2D1659 Caterpillar Weight(lbs): 82.00 Length(cm): 127.0000 Width(cm): 35.6000 Depth(cm): 30.5000
Compatible equipment models: 2D1659:
Information:
Use this procedure if one of the following event codes are active. Refer to Troubleshooting, "Event Codes" for information about event codes. For information on the engine monitoring system, refer to Troubleshooting, "Engine Monitoring System".
Table 1
Diagnostic Trouble Codes    
J1939 Code    CDL Code    Code Description
(code descriptions may vary)    Comments    
5480-16     E1430 (2)     Aftertreatment 1 Diesel Exhaust Fluid Controller Temperature : High - moderate severity (2)     The temperature of the Diesel Exhaust Fluid Control Unit (DCU) has exceeded the trip point of 116° C (240° F).    
Illustration 1 g02931976
Complete the procedure in the order in which the steps are listed.
Table 2
Troubleshooting Test Steps    Values    Results    
1. Determine the Source of the High Temperature
A. Evaluate the installation location of the DCU.
B. Check for heat sources close to the DCU.
   
Heat Source
   
Result: The DCU is located close to a heat source.
Repair: Eliminate the heat source by installing a heat shield or moving the component creating the heat.
Proceed to Test Step 2.
   
2. Replace the DCU
A. Replace the DCU.
    DCU    
Result: The DCU was replaced.
Verify that the problem is resolved.
   
Table 1
Diagnostic Trouble Codes    
J1939 Code    CDL Code    Code Description
(code descriptions may vary)    Comments    
5480-16     E1430 (2)     Aftertreatment 1 Diesel Exhaust Fluid Controller Temperature : High - moderate severity (2)     The temperature of the Diesel Exhaust Fluid Control Unit (DCU) has exceeded the trip point of 116° C (240° F).    
Illustration 1 g02931976
Complete the procedure in the order in which the steps are listed.
Table 2
Troubleshooting Test Steps    Values    Results    
1. Determine the Source of the High Temperature
A. Evaluate the installation location of the DCU.
B. Check for heat sources close to the DCU.
   
Heat Source
   
Result: The DCU is located close to a heat source.
Repair: Eliminate the heat source by installing a heat shield or moving the component creating the heat.
Proceed to Test Step 2.
   
2. Replace the DCU
A. Replace the DCU.
    DCU    
Result: The DCU was replaced.
Verify that the problem is resolved.
   
Caterpillar parts catalog:
Parts rack Caterpillar catalog:
5D4010
RACK
120, 120B, 12E, 140, 140B, 14E
120, 120B, 12E, 140, 140B, 14E
5D4010
RACK
120, 120B, 12E, 140, 140B, 14E
120, 120B, 12E, 140, 140B, 14E
0814540
RACK
CB-534
CB-534
4Y1633
RACK STRIP
980C
980C
4V8038
RACK STRIP
980C
980C
0952160
RACK
E120, E140
E120, E140
2D5411
RACK
12E
12E
5D0368
RACK
12E
12E
3D9437
RACK
12E
12E
2D6371
RACK
12E
12E
5D1619
RACK
16
16