RACK-REGULATOR 4N0900 - Caterpillar

Illustration 1 g02843936
Top view
Illustration 2 g02843937
Right side view
Typical example
Table 1
Specification for 8N-6164 Oil Pan Gp and 152-6013 Oil Pan Gp
Item Qty Part Specification Description
- 15 1A-2029 Bolt Use the following procedure in order to tighten the bolts:
1. Tighten five bolts (12) to standard torque.
2. Tighten bolt (1) through bolt (10) in a numerical sequence that is shown in Illustration 1 to standard torque.
11 - - Before assembly, apply red Loctite 593 or Loctite 5399 to the joints of the gasket.
13 - - Before assembly, lightly lubricate the bore for the O-ring seals with the lubricant that is being sealed or an approved equivalent.
14 - - Before assembly, apply red Loctite 593 or Loctite 5399 on connecting joint of the flywheel housing (17) and the rear of cylinder block, and connecting joint of the front accessory drive housing (18) and the front of cylinder block.
15 1 142-4159 Integral Seal Before assembly, apply red Loctite 593 or Loctite 5399 to the sealing surface.
16 38 5P-5855 Bolt Apply blue Loctite 243 to the open top end of the bolt holes after assembly of the oil pan.
19 1 4B-2363 Oil Drain Plug Torque to 145 15 N m (107 11 lb ft).
20 1 6I-0723 Oil Drain Plug Torque to 110 15 N m (81 11 lb ft).