RADIATOR GP 1609678 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7574     Link Bracket     2    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01306221
Attach Tooling (A) and a suitable lifting device to piston pump (9). The weight of piston pump (9) is approximately 90 kg (198 lb). Position piston pump (9) and install bolts (10) .
Illustration 2 g01306209
Position manifold assembly (6) and install bolts (8). Connect clamp (7) .
Illustration 3 g01306206
Install tube assemblies (4) and (5) .
Illustration 4 g01306213
Position bracket assembly (2). Connect all hose assemblies (1) and harness assemblies (3) onto the pumps. Connect all mounting hardware from the pumps.End By: Install the piston pumps. Refer to Disassembly and Assembly, "Pump Mounting - Install".