RADIATOR & FAN GP 1W0690 - Caterpillar

Installation Procedure
Table 1
Tools Needed     A     B     C    
1U-7505 Hydraulic Jack     1            
6V-2082 Lifting Hook         1        
5P-9736 Link Bracket         2        
8S-9906 Ratchet Puller             1    
Illustration 1 g00713786
Put the torque converter in position under the machine.
Fasten a hoist to Tooling (B). Fasten Tooling (C) to Tooling (B) and the torque converter.
Use Tool (C) and raise the torque converter off the ground.
Illustration 2 g00713790
Put Tool (A) in position under torque converter (11). Fasten the torque converter to Tool (A) .
Illustration 3 g00713797
Install two 3/8 inch - 16 NC guide bolts (12) in the flywheel housing.
The O-ring seal must be in position on the torque converter housing.
Put the torque converter in position on the flywheel housing. Install the four bolts that hold the torque converter in place.
Remove Tool (A) .
Illustration 4 g00713801
Install two bolts (8) .
Illustration 5 g00713806
Put tube assembly (6) and clamp (7) in position. Install the bolt that holds the parts in place.
Illustration 6 g00713807
Connect hoses (3), (4), and (5) .
Illustration 7 g00713814
Put bracket (1) in position. Install the bolt that holds the bracket in place.
Connect two wire harnesses (2). Put the wire harnesses in position in the clips.Refer to the Disassembly And Assembly Manual, Senora for the procedure to install the implement pump., End By:
Install the torque converter outlet relief valve. Refer to Disassembly and Assembly, "Torque Converter Outlet Relief Valve - Install".
Install the power train oil pump. Refer to Disassembly and Assembly, "Power Train Oil Pump - Install".
Install the implement pump. Refer to Disassembly and AssemblySENR9486, "Implement Pump - Install".
Install the drive shaft. Refer to Disassembly and Assembly, "Main Drive Shaft - Remove and Install".